MB90337PMC 查看數據表（PDF） - Fujitsu

零件编号

产品描述 (功能)

生产厂家

MB90337PMC

16-bit Microcontroller

Fujitsu 

MB90335 Series

■ HANDLING DEVICES

1. Preventing latch-up and turning on power supply

latch-up may occur on CMOS IC under the following conditions:

• If a voltage higher than VCC or lower than VSS is applied to input and output pins.

• A voltage higher than the rated voltage is applied between VCC and VSS.

When latch-up occurs, power supply current increases rapidly and might thermally damage elements. When

using CMOS IC, take great care to prevent the occurrence of latch-up.

2. Treatment of unused pins

Leaving unused input pins unconnected can cause abnormal operation or latch-up, leading to permanent dam-

age. Unused input pins should always be pulled up or down through resistance of at least 2 kΩ. Any unused

input/output pins may be set to output mode and left open, or set to input mode and treated the same as unused

input pins. If there is unused output pin, make it to open.

3. About the attention when the external clock is used

Even when using an external clock signal, an oscillation stabilization delay is applied after a power-on reset or

when recovering from sub-clock or stop mode. When suing an external clock, 25 MHz should be the upper

frequency limit.

The following figure shows a sample use of external clock signals.

• Using external clock

X0

OPEN X1

4. Treatment of power supply pins (VCC/VSS)

In products with multiple VCC or VSS pins, the pins of the same potential are internally connected in the device

to avoid abnormal operations including latch-up. However, you must connect the pins to external power supply

and a ground line to lower the electro-magnetic emission level, to prevent abnormal operation of strobe signals

caused by the rise in the ground level, and to conform to the total output current rating.

Moreover, connect the current supply source with the VCC and VSS pins of this device at the low impedance.

It is also advisable to connect a ceramic bypass capacitor of approximately 0.1 μF between VCC and VSS pins

near this device.

5. About crystal oscillator circuit

Noise near the X0 and X1 pins may cause the device to malfunction. Design the printed circuit board so that

X0, X1, the crystal oscillator (or ceramic oscillator) , and the bypass capacitor to ground are located as close to

the device as possible.

It is strongly recommended to design the PC board artwork with the X0 and X1 pins surrounded by ground plane

because stable operation can be expected with such a layout.

Please ask the crystal maker to evaluate the oscillational characteristics of the crystal and this device.

6. Caution on Operations during PLL Clock Mode

On this microcontroller, if in case the crystal oscillator breaks off or an external reference clock input stops while

the PLL clock mode is selected, a self-oscillator circuit contained in the PLL may continue its operation at its

self-running frequency. However, Fujitsu will not guarantee results of operations if such failure occurs.

10

DS07-13735-6E

Share Link: