CDP6805E2CE 查看數據表（PDF） - InnovASIC, Inc

零件编号

产品描述 (功能)

生产厂家

CDP6805E2CE

Microprocessor Unit

InnovASIC, Inc 

IA6805E2

Microprocessor Unit

Data Sheet

As of Production Version 00

The counter continues to count past zero, falling from $00 to $FF, and continues. The

processor may read the counter at any time without disturbing the count by reading the

timer data register (TDR). This allows a program to determine the length of time since a

timer interrupt has occurred. The timer interrupt request bit remains set until cleared by

software. The interrupt is lost if this happens before the timer interrupt is serviced.

The prescaler is a 7-bit divider used to extend the maximum length of the timer. TCR bits

0-2 are programmed to choose the appropriate prescaler output, which is used as the count

input. The prescaler is cleared by writing a “1” into TCR bit 3, which avoids truncation

errors. The processor cannot write to or read from the prescaler.

Timer Input Mode 1:

When TCR4 = 0 and TCR5 = 0, the input to the timer is from an internal clock and the

timer input is disabled. The internal clock mode can be used for periodic interrupt

generation as well as a reference for frequency and event measurement. The internal clock is

the instruction cycle clock and is coincident with Address Strobe (AS) except during the wait

instruction where it goes low. During the wait instruction the internal clock to the timer

continues to run at its normal rate.

Timer Input Mode 2:

When TCR4 = 1 and TCR5 = 0, the internal clock and timer input signal are ANDed to

form the timer input. This mode can be used to measure external pulse widths. The external

pulse turns on the internal clock for the duration of the pulse. The count accuracy in this

mode is ±1 clock. Accuracy improves with longer input pulse widths.

Timer Input Mode 3:

When TCR4 = 0 and TCR5 = 1, all inputs to the timer are disabled.

Timer Input Mode 4:

When TCR4 = 1 and TCR5 = 1, the internal clock input to the timer is disabled and the

timer input then comes from the external TIMER pin. The external clock can be used to

count external events as well as to provide an external frequency for generating periodic

interrupts.

Copyright © 2002

innovASIC



The End of Obsolescence™

ENG21108140100

Page 16 of 31

www.innovasic.com

Customer Support:

1-888-824-4184

Share Link: