MC56F8345 查看數據表（PDF） - Motorola => Freescale

零件编号

产品描述 (功能)

生产厂家

MC56F8345

16-bit Hybrid Controller

Motorola => Freescale 

Freescale Semiconductor, Inc.

software routines that can be used to program the main Program and Data Flash memory areas.

Both Program and Data Flash memories can be independently bulk erased or erased in pages.

Program Flash page erase size is 1KB. Boot and Data Flash page erase size is 512 bytes. The Boot

Flash memory can also be either bulk or page erased.

A key application-specific feature of the 56F8345 is the inclusion of two Pulse Width Modulator

(PWM) modules. These modules each incorporate three complementary, individually

programmable PWM signal output pairs (each module is also capable of supporting six

independent PWM functions, for a total of 12 PWM outputs) to enhance motor control

functionality. Complementary operation permits programmable dead time insertion, distortion

correction via current sensing by software, and separate top and bottom output polarity control. The

up-counter value is programmable to support a continuously variable PWM frequency.

Edge-aligned and center-aligned synchronous pulse width control (0% to 100% modulation) is

supported. The device is capable of controlling most motor types: ACIM (AC Induction Motors);

both BDC and BLDC (Brush and Brushless DC motors); SRM and VRM (Switched and Variable

Reluctance Motors); and stepper motors. The PWMs incorporate fault protection and

cycle-by-cycle current limiting with sufficient output drive capability to directly drive standard

optoisolators. A “smoke-inhibit”, write-once protection feature for key parameters is also included.

A patented PWM waveform distortion correction circuit is also provided. Each PWM is

double-buffered and includes interrupt controls to permit integral reload rates to be programmable

from 1 to 16. The PWM modules provide reference outputs to synchronize the Analog-to-Digital

Converters through two channels of Quad Timer C.

The 56F8345 incorporates two Quadrature Decoders capable of capturing all four transitions on

the two-phase inputs, permitting generation of a number proportional to actual position. Speed

computation capabilities accommodate both fast- and slow-moving shafts. An integrated watchdog

timer in the Quadrature Decoder can be programmed with a time-out value to alert when no shaft

motion is detected. Each input is filtered to ensure only true transitions are recorded.

This hybrid controller also provides a full set of standard programmable peripherals that include

two Serial Communications Interfaces (SCIs); two Serial Peripheral Interfaces (SPIs); and four

Quad Timers. Any of these interfaces can be used as General Purpose Input/Outputs (GPIOs) if

that function is not required. A Flex Controller Area Network (FlexCAN) interface (CAN Version

2.0 B-compliant) and an internal interrupt controller are also a part of the 56F8345.

1.3 Award-Winning Development Environment

Processor ExpertTM (PE) provides a Rapid Application Design (RAD) tool that combines

easy-to-use component-based software application creation with an expert knowledge system.

The CodeWarrior Integrated Development Environment is a sophisticated tool for code navigation,

compiling, and debugging. A complete set of evaluation modules (EVMs) and development

system cards will support concurrent engineering. Together, PE, CodeWarrior and EVMs create a

complete, scalable tools solution for easy, fast, and efficient development.

6

56F8345 Technical Data

For More Information On This Product,

Go to: www.freescale.com

Preliminary

Share Link: