TYPICAL CONNECTION CIRCUIT
The connection circuit shown above is for the MSK 1901. The RL and LP are external components and must
not be located near ground planes if possible. A high quality resistor such as Bradford Electronics P/N FP10-200
is reqired for optimum response times. Use an inductor with a high self-resonant frequency that can withstand
the currents required for the application. The ferrite beads should be located as close to the DUT as possible.
Fare-Rite Corporation P/N 2743001111 beads work well for most applications. For additional applications informa-
tion, please contact MSK. Evaluation amplifiers with test boards are readily available upon request.
NOTES:
5
Rev. A 5/02