MSM80C85 查看數據表（PDF） - Oki Electric Industry

零件编号

产品描述 (功能)

生产厂家

MSM80C85

8-Bit CMOS MICROPROCESSOR

Oki Electric Industry 

¡ Semiconductor

MSM80C85AHRS/GS/JS

POWER DOWN Mode

The MSM80C85AH is compatible with the MSM80C85A in function and POWER DOWN mode.

This reduces power consumption further.

There are two methods available for starting this POWER DOWN mode. One is through

software control by using the HALT command and the other is under hardware control by using

the pin HOLD. This mode is released by the HOLD, RESET, and interrupt pins (TRAP, RST7.5,

RST6.5 RST5.5, or INTR). (See Table 4.)

Since the sequence of HALT, HOLD, RESET, and INTERRUPT is compatible with MSM80C85A,

every the POWER DOWN mode can be used with no special attention.

Table 4 POWER DOWN Mode Releasing Method

Start by means of Halt command

Start by means of HOLD pin

Released by using pins RESET and INTERRUPT (not by pin HOLD)

Released by using RESET and HOLD pins (not by interrupt pins)

(1) Start by means of HALT command (See Figures 6 and 7.)

The POWER DOWN mode can be started by executing the HALT command.

At this time, the system is put into the HOLD status and therefore the POWER DOWN mode

cannot be released even when the HOLD is released later.

In this case, the POWER DOWN mode can be released by means of the RESET or interrupt.

(2) Start by means of HOLD pin (See Figure 8.)

During the execution of commands other than the HALT, the POWER DOWN mode is started

when the system is put into HOLD status by means of the HOLD pin.

Since no interrupt works during the execution of the HOLD, the POWER DOWN mode cannot

be released by means of interrupt pins. In this case, the POWER DOWN mode can be released

either by means of the RESET pin or by releasing the HOLD status by means of HOLD pin.

11/29

Share Link: