NL10276AC30-01 查看數據表（PDF） - NEC => Renesas Technology

零件编号

产品描述 (功能)

生产厂家

NL10276AC30-01

38 cm (15 inches), 1024 × 768 pixels, Full-color, Multi-scan Function, Built-in backlight with inverter Ultra wide viewing angle

NEC => Renesas Technology 

NL10276AC30-01A

POWER SUPPLY SEQUENCE

There is no sequence among the synchronous signals, the video signals and the power supply. However, 12 V

for backlight should be started up within 80 ms, otherwise, the protection circuit makes the backlight turns off.

Please note that the supply voltage must not be applied while the control signals (SEL, UP, DOWN and RESET)

are connected to GND. Otherwise the module may cause malfunctions.

If the power supply voltage is applied while SEL and RESET is connected to GND, the mode is set into NEC

factory mode. In this case, both LEDON and LEDOFF become “H”. Please do not use the module in this mode

which may write over the default value. Please turn off the power supply immediately and turn on the power while

SEL and RESET are connected to GND again. If the default value has been revised by accident, please follow the

instruction below.

<NEC factory mode>

This mode can control Brightness and Contrast and OSD position. Factory Reset function is reset all values. But

do not use the module in this mode which may write over the default values affect to the LCD internal operation.

Please turn off the power immediately and turn on the power while SEL and RESET are connected to GND again.

If the default value has been revised by accident, please select “Factory Reset” mode and press “Reset” key for

over two seconds.

Functions

Brightness

Contrast

LCD Data

Color adjust

VCO

HDTV Select

OSD position

Factory Reset

RESET

Control contents

Total Brightness and Sub Brightness for each RGB

Total Contrast and Sub Contrast for each RGB

Never select and adjust values

Change the OSD display position

Above function values is reset to factory values.

RESET the NEC factory mode

How to reset

Press RESET key over 2 seconds

Press RESET key over 2 seconds

Please go to the Factory reset.

−

Press Reset key over 2 seconds.

−

Data Sheet EN0417EJ1V0DS00

7

Share Link: