NTE2716 查看數據表（PDF） - NTE Electronics
零件编号
产品描述 (功能)
生产厂家
NTE2716 Datasheet PDF : 5 Pages
| |||
Mode Selection:
Mode
Pin Number
Read
Output Disable
Standby
Program
Program Verify
Program Inhibit
9–11, 13–17
12
18
20
21
24
DQ
VSS
E/Progr
G (Note3)
VPP
VCC
Data Out
VSS
VIL
VIL
VCC (Note 3)
VCC
High Z
VSS
Don’t Care
VIH
VCC (Note 3)
VCC
High Z
VSS
VIH
Don’t Care
VCC
VCC
Data In
VSS
Pulsed VIL to VIH
VIH
VPPH
VCC
Data Out
VSS
VIL
VIL
VPPH
VCC
High Z
VSS
VIL
VIH
VPPH
VCC
Note 3. In Read Mode if VPP ≥ VIH, then G (active low)
VPP ≤ VIL, then G (active high)
Capacitance: (f = 1MHz, TA = +25°C, periodically sampled rather than 100% tested)
Parameter
Symbol
Test Conditions
Min Typ Max Unit
Input Capacitance
Cin Vin = 0V
– 4.0 6.0 pF
Output capacitance
Cout Vout = 0V
– 8.0 12.0 pF
Note 4. Capacitance measured with a Boonton Meter or
effective capacitance calculated from the equation:
C = I∆t
∆V
DC Operating Conditions and Characteristics: (Full Operating Voltage and Temperature Range
unless otherwise specified)
Parameter
Symbol
Test Conditions
Min Typ Max Unit
Recommended DC Read Operating Conditions
Supply Voltage
VCC, VPP Note 5
Input High Voltage
VIH
Input Low Voltage
VIL
Recommended DC Operating Conditions
4.75 5.0 5.25 V
2.0 – VCC+1.0 V
–0.1 – +0.8 V
Address, G and E/Progr Input Sink Current
Iin
Vin = 5.25V
––
Output Leakage Current
ILO Vout = 5.25V, G = 5V
––
VCC Supply Current (Standby)
ICC1 E/Progr = VIH, G = VIL
––
VCC Supply Current (Active)
ICC2 Outputs Open, G = E/Progr = VIL –
–
VCC Supply Current
IPP1 VPP = 5.25V, Note 5
––
Output Low Voltage
VOL IOL = 2.1mA
––
Output High Voltage
VOH IOH = –400µA
2.4 –
10 µA
10 µA
25 mA
100 mA
5
mA
0.45 V
–
V
Note 5. VCC must be applied simultaneously or prior to VPP. VCC must also be switched off simulta-
neously with or after VPP. With VPP connected directly to VCC during the read operation, the
supply current would then be the sum of IPP1 and ICC.
Share Link: 