PA-1001AIAB1 查看數據表（PDF） - Unspecified

零件编号

产品描述 (功能)

生产厂家

PA-1001AIAB1

SIGNAL CONDITIONERS & CONVERTERS

Unspecified 

Wiring For Magnetic Pickup Coil:

1. Connect a two conductor shielded cable from the pickup to Terminals 1 and 2. Connect the

shield to Terminal 4 (see Figure 2). NOTE: It is also preferable that the pickup coil be grounded

to the shield.

2. Connect a power source, which must be within 8-30 VDC, to Terminals 7 and 8. The Plus

voltage is connected to Terminal 8 and the Return to Terminal 7(see Figure 2).

3. Connect the Pulse output wire to Terminal 3, and connect the Pulse common to Terminal 4 (see

Figure 2).

4. Set Jumper HD2 (see Figure 3) to the MAG position.

5. Configure Jumper HD1 (see Figure 3) to the desired pulse output as follows:

Pulse Output Type

Open Collector

Square Wave to Vin

TTL/CMOS

0-10 VDC Square Wave

HD1 Jumper Configuration

JP2

JP1 and JP2

JP1, JP2 and JP3

JP1, JP2 and JP4

5. Install pickup (e.g. in meter) and provide power to PA1001A. Determine if pulse output

is being generated in the absence of motion. Adjust the MAG Trigger (R19) (see Figure

3) clock wise until the false pulsation has stopped.

PA1001A – 7/02

Page 6 of 11

Share Link: