PA83U 查看數據表（PDF） - Cirrus Logic

零件编号

产品描述 (功能)

生产厂家

PA83U

High Voltage Power Operational Amplifiers

Cirrus Logic 

PA83 • PA83A

Product Innova tionFrom

GENERAL

Please read Application Note 1 "General Operating Consider-

ations" which covers stability, supplies, heat sinking, mounting,

current limit, SOA interpretation, and specification interpretation.

Visit www.Cirrus.com for design tools that help automate tasks

such as calculations for stability, internal power dissipation,

current limit and heat sink selection. The "Application Notes"

and "Technical Seminar" sections contain a wealth of informa-

tion on specific types of applications. Package outlines, heat

sinks, mounting hardware and other accessories are located

in the "Packages and Accessories" section. Evaluation Kits

are available for most Apex Precision Power product models,

consult the "Evaluation Kit" section for details. For the most

current version of all Apex Precision Power product data sheets,

visit www.Cirrus.com.

SAFE OPERATING AREA (SOA)

The bipolar output stage of this high voltage amplifier has

two distinct limitations.

1. The internal current limit, which limits maximum available

output current.

2. The second breakdown effect, which occurs whenever the

simultaneous collector current and collector-emitter voltage

SOA

200

150

INTERNAL CURRENT LIMIT

100

70

50

40

30

1. The following capacitive and inductive loads are safe:

±VS

150V

125V

100V

75V

50V

C(MAX)

.7 F

2.0µF

5.µF

60µF

ALL

L(MAX)

1.5H

2.5H

6.0H

30H

ALL

2. Short circuits to ground are safe with dual supplies up to

120V or single supplies up to 120V.

3. Short circuits to the supply rails are safe with total supply

voltages up to 120V, e.g. ±60V.

4. The output stage is protected against transient flyback.

However, for protection against sustained, high energy

flyback, external fast-recovery diodes should be used.

INDUCTIVE LOADS

Two external diodes as shown in Figure 1, are required

to protect these amplifiers against flyback (kickback) pulses

exceeding the supply voltages of the amplifier when driving

inductive loads. For component selection, these external diodes

must be very quick, such as ultra fast recovery diodes with

no more than 200 nanoseconds of reverse recovery time. Be

sure the diode voltage rating is greater than the total of both

supplies. The diode will turn on to divert the flyback energy

into the supply rails thus protecting the output transistors from

destruction due to reverse bias.

A note of caution about the supply. The energy of the flyback

pulse must be absorbed by the power supply.As a result, a tran-

sient will be superimposed on the supply voltage, the magnitude

of the transient being a function of its transient impedance and

current sinking capability. If the supply voltage plus transient

exceeds the maximum supply rating or if the AC impedance

of the supply is unknown, it is best to clamp the output and the

supply with a zener diode to absorb the transient.

+VS

20

80

100 120

150

200

250 300

INTERNAL VOLTAGE DROP, SUPPLY TO OUTPUT (V)

exceed specified limits.

The SOA curves combine the effect of these limits. For a

given application, the direction and magnitude of the output

current should be calculated or measured and checked against

the SOA curves. This is simple for resistive loads but more

complex for reactive and EMF generating loads. However,

the following guidelines may save extensive analytical efforts:

–VS

FIGURE 1. PROTECTION, INDUCTIVE LOAD

4

PA83U

Share Link: