PCF8563P 查看數據表（PDF） - NXP Semiconductors.

零件编号

产品描述 (功能)

生产厂家

PCF8563P

Real-time clock/calendar

NXP Semiconductors. 

NXP Semiconductors

PCF8563

Real-time clock/calendar

7.2 Pin description

Table 3. Pin description

Symbol

Pin

DIP8, SO8, TSSOP8

OSCI

1

OSCO

2

INT

3

VSS

4

SDA

5

SCL

6

CLKOUT

7

VDD

8

n.c.

-

HVSON10

1

2

4

5[1]

6

7

8

9

3, 10

Description

oscillator input

oscillator output

interrupt output (open-drain; active LOW)

ground

serial data input and output

serial clock input

clock output, open-drain

supply voltage

not connected; do not connect and do not

use as feed through

[1] The die paddle (exposed pad) is wired to VSS but should not be electrically connected.

8. Functional description

The PCF8563 contains sixteen 8-bit registers with an auto-incrementing register address,

an on-chip 32.768 kHz oscillator with one integrated capacitor, a frequency divider which

provides the source clock for the Real-Time Clock (RTC) and calender, a programmable

clock output, a timer, an alarm, a voltage-low detector, and a 400 kHz I2C-bus interface.

All 16 registers are designed as addressable 8-bit parallel registers although not all bits

are implemented. The first two registers (memory address 00h and 01h) are used as

control and/or status registers. The memory addresses 02h through 08h are used as

counters for the clock function (seconds up to years counters). Address locations 09h

through 0Ch contain alarm registers which define the conditions for an alarm.

Address 0Dh controls the CLKOUT output frequency. 0Eh and 0Fh are the Timer_control

and Timer registers, respectively.

The Seconds, Minutes, Hours, Days, Months, Years as well as the Minute_alarm,

Hour_alarm, and Day_alarm registers are all coded in Binary Coded Decimal (BCD)

format.

When one of the RTC registers is written or read, the contents of all time counters are

frozen. Therefore, faulty writing or reading of the clock and calendar during a carry

condition is prevented.

8.1 CLKOUT output

A programmable square wave is available at the CLKOUT pin. Operation is controlled by

the register CLKOUT_control at address 0Dh. Frequencies of 32.768 kHz (default),

1.024 kHz, 32 Hz, and 1 Hz can be generated for use as a system clock, microcontroller

clock, input to a charge pump, or for calibration of the oscillator. CLKOUT is an open-drain

output and enabled at power-on. If disabled it becomes high-impedance.

PCF8563

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 9 — 16 June 2011

© NXP B.V. 2011. All rights reserved.

5 of 45

Share Link: