PCF8575 查看數據表（PDF） - NXP Semiconductors.
零件编号
产品描述 (功能)
生产厂家
PCF8575 Datasheet PDF : 24 Pages
| |||
Philips Semiconductors
Remote 16-bit I/O expander for I2C-bus
Product specification
PCF8575
7 FUNCTIONAL DESCRIPTION
7.1 Quasi-bidirectional I/Os
The PCF8575’s 16 ports (see Fig.7) are entirely independent and can be used either as input or output ports. Input data
is transferred from the ports to the microcontroller in the READ mode (see Fig.10). Output data is transmitted to the ports
in the WRITE mode (see Fig.9).
This quasi-bidirectional I/O can be used as an input or output without the use of a control signal for data direction.
At power-on the I/Os are HIGH. In this mode only a current source (IOH) to VDD is active. An additional strong pull-up to
VDD (IOHt) allows fast rising edges into heavily loaded outputs. These devices turn on when an output is written HIGH,
and are switched off by the negative edge of SCL. The I/Os should be HIGH before being used as inputs. After power-on
as all the I/Os are set HIGH all of them can be used as input. Any change in setting of the I/Os as either inputs or outputs
can be done with the write mode. Warning: If a HIGH is applied to an I/O which has been written earlier to LOW, a large
current (IOL) will flow to VSS. (see Characteristics note 3).
dbook, full pagewidth
write pulse
data from
shift register
power-on
reset
read pulse
data to
shift register
DQ
FF
CI
S
IOHt
IOH
100
µA
IOL
VDD
P00 to P07
P10 to 17
DQ
FF
CI
S
VSS
MGL540
to interrupt
logic
Fig.7 Simplified schematic diagram of each I/O.
7.2 Addressing
Figures 8, 9 and 10 show the address and timing diagrams. Before any data is transmitted or received the master must
send the address of the receiver via the SDA line. The first byte transmitted after the START condition carries the address
of the slave device and the read/write bit. The address of the slave device must not be changed between the START and
the STOP conditions. The PCF8575 acts as a slave receiver or a slave transmitter.
1999 Apr 07
handbook, halfpage
slave address
S 0 1 0 0 A2 A1 A0 R/W A
MGL541
Fig.8 Byte containing the slave address and the R/W bits.
8
Share Link: 