LTC1196(Rev_0) 查看數據表（PDF） - Linear Technology
零件编号
产品描述 (功能)
生产厂家
LTC1196 Datasheet PDF : 28 Pages
| |||
APPLICATI S I FOR ATIO
CS
1
2
3
CLK
DUMMY BITS LATCHED
BY LTC1198
4
5
LTC1196/LTC1198
DATA (DIN/DOUT)
START
SGL/DIFF
ODD/SIGN
DUMMY
DUMMY
B7
B6
THE DIGITAL SYSTEM CONTROLS DATA LINE
AND SENDS MUX ADDRESS TO LTC1198
THE DIGITAL SYSTEM MUST RELEASE
DATA LINE AFTER 5TH RISING CLK
AND BEFORE THE 5TH FALLING CLK
LTC1198 CONTROLS DATA LINE AND SENDS
A/D RESULT BACK TO THE DIGITAL SYSTEM
LTC1198 TAKES CONTROL OF
DATA LINE ON 5TH FALLING CLK
1196/98 F04
Figure 4. LTC1198 Operation with DIN and DOUT Tied Together
10
LT1196 VCC = 5V
1
LT1196 VCC = 2.7V
0.1 LT1198 VCC = 5V
0.01
LT1198 VCC = 2.7V
Minimize CS Low Time (LTC1198)
In systems that have significant time between conver-
sions, lowest power drain will occur with the minimum CS
low time. Bringing CS low, transfering data as quickly as
possible, then bringing it back high will result in the lowest
current drain. This minimizes the amount of time the
device draws power.
0.001
100
1k
10k
100k
1M
SAMPLE RATE (Hz)
1196/98 F05
Figure 5. Supply Current vs Sample Rate for LTC1196/
LTC1198 Operating on 5V and 2.7V Supplies
When the CS pin is high (= supply voltage), the LTC1198
is in shutdown mode and draws only leakage current. The
status of the DIN and CLK input has no effect on the supply
current during this time. There is no need to stop DIN and
CLK with CS = high; they can continue to run without
drawing current.
OPERATING ON OTHER THAN 5V SUPPLIES
The LTC1196/LTC1198 operate from single 2.7V to 6V
supplies. To operate the LTC1196/LTC1198 on other than
5V supplies, a few things must be kept in mind.
Input Logic Levels
The input logic levels of CS, CLK and DIN are made to
meet TTL on 5V supply. When the supply voltage varies,
the input logic levels also change (see typical curve of
Digital Input Logic Threshold vs Supply Voltage). For
these two ADCs to sample and convert correctly, the
digital inputs have to be in the logical low and high relative
to the operating supply voltage. If achieving micropower
consumption is desirable on the LTC1198, the digital
inputs must go rail-to-rail between supply voltage and
ground (see Reducing Power Consumption section).
17
Share Link: 