RT9246PC 查看數據表（PDF） - Richtek Technology

零件编号

产品描述 (功能)

生产厂家

RT9246PC

Multi-Phase PWM Controller for CPU Core Power Supply

Richtek Technology 

Functional Pin Description

VID4 (Pin 1), VID3 (Pin 2), VID2 (Pin 3), VID1 (Pin 4),

VID0 (Pin 5)

DAC voltage identification inputs for K8. These pins are

internally pulled to 2.4V if left open.

SS2 (Pin 6)

DAC O/P ramping speed control for K8. Connect this pin

to GND with a capacitor to set the rising/falling time at

VID jump.

SGND (Pin 7)

VCORE differential sense negative input.

FB (Pin 8)

Inverting input of the internal error amplifier.

COMP (Pin 9)

Output of the error amplifier and input of the PWM

comparator.

PGOOD (Pin 10)

Power good open-drain output.

DVD (Pin 11)

Programmable power UVLO detection or converter enable

input.

SS (Pin 12)

Connect this SS pin to GND with a capacitor to set the

soft-start time interval.

450

400

350

300

250

200

150

100

50

0

0

Frequency vs. RRT

10 20 30 40 50 60 70

RRT (k Ω)

DS9246-06 March 2007

RT9246

RT (Pin 13)

Switching frequency setting. Connect this pin to GND with

a resistor to set the frequency.

VOSS (Pin 14)

VCORE initial value offset. Connect this pin to GND with a

resistor to set the offset value.

IMAX (Pin 15)

Over-Current protection set.

VSEN (Pin 16)

VCORE differential sense positive input.

VDIF (Pin 17)

VCORE differential sense output.

ADJ (Pin 18)

Current sense output for active droop adjust. Connect a

resistor from this pin to GND to set the load droop.

GND (Pin 19)

IC ground.

ISN23 (Pin 20)

RDS(ON) current sense inputs from converter 2nd & 3rd phase

channel sense components' GND node.

ISP1 (Pin 23), ISP2 (Pin 22), ISP3 (Pin 21)

RDS(ON) current sense inputs for individual converter

channels. Tie this pin to the component's sense node.

ISN1 (Pin 24)

RDS(ON) current sense inputs from converter 1st channel

sense component's GND node.

PWM1 (Pin 27), PWM2 (Pin 26), PWM3 (Pin 25)

PWM outputs for each driven channel. Connect these pins

to the PWM input of the MOSFET driver. For systems

which use 2 channels, connect PWM3 high.

VCC (Pin 28)

IC power supply. Connect this pin to a 5V supply.

www.richtek.com

3

Share Link: