SAM4S 查看數據表（PDF） - Atmel Corporation

零件编号

产品描述 (功能)

生产厂家

SAM4S

AT91SAM ARM-based Flash MCU

Atmel Corporation 

SAM4S Series [Preliminary]

5. Power Considerations

5.1 Power Supplies

The SAM4S has several types of power supply pins:

• VDDCORE pins: Power the core, the embedded memories and the peripherals. Voltage

ranges from 1.08V to 1.32V.

• VDDIO pins: Power the Peripherals I/O lines (Input/Output Buffers), USB transceiver, Backup

part, 32 kHz crystal oscillator and oscillator pads. Voltage ranges from 1.62V to 3.6V.

• VDDIN pin: Voltage Regulator Input, ADC, DAC and Analog Comparator Power Supply.

Voltage ranges from 1.62V to 3.6V.

• VDDPLL pin: Powers the PLLA, PLLB, the Fast RC and the 3 to 20 MHz oscillator. Voltage

ranges from 1.08V to 1.32V.

5.2 Voltage Regulator

The SAM4S embeds a voltage regulator that is managed by the Supply Controller.

This internal regulator is designed to supply the internal core of SAM4S. It features two operat-

ing modes:

• In Normal mode, the voltage regulator consumes less than 500 µA static current and draws

80 mA of output current. Internal adaptive biasing adjusts the regulator quiescent current

depending on the required load current. In Wait Mode quiescent current is only 5 µA.

• In Backup mode, the voltage regulator consumes less than 1 µA while its output (VDDOUT)

is driven internally to GND. The default output voltage is 1.20V and the start-up time to reach

Normal mode is less than 300 µs.

For adequate input and output power supply decoupling/bypassing, refer to the “Voltage Regula-

tor” section in the “Electrical Characteristics” section of the datasheet.

5.3 Typical Powering Schematics

The SAM4S supports a 1.62V-3.6V single supply mode. The internal regulator input is con-

nected to the source and its output feeds VDDCORE. Figure 5-1 below shows the power

schematics.

As VDDIN powers the voltage regulator, the ADC, DAC and the analog comparator, when the

user does not want to use the embedded voltage regulator, it can be disabled by software via

the SUPC (note that this is different from Backup mode).

19

11100BS–ATARM–31-Jul-12

Share Link: