DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

SAM4S 查看數據表(PDF) - Atmel Corporation

零件编号
产品描述 (功能)
生产厂家
SAM4S
Atmel
Atmel Corporation Atmel
SAM4S Datasheet PDF : 67 Pages
First Prev 21 22 23 24 25 26 27 28 29 30 Next Last
SAM4S Series [Preliminary]
Figure 5-3. Backup Battery
Backup
Battery +
-
Main Supply
IN
OUT
3.3V
LDO
ON/OFF
ADC, DAC, Analog
Comparator Supply
(2.0V-3.6V)
VDDIO
VDDIN
VDDOUT
VDDCORE
VDDPLL
USB
Transceivers.
ADC, DAC
Analog Comp.
Voltage
Regulator
PIOx (Output)
External wakeup signal
WAKEUPx
Note: The two diodes provide a “switchover circuit” (for illustration purpose)
between the backup battery and the main supply when the system is put in
backup mode.
5.4 Active Mode
Active mode is the normal running mode with the core clock running from the fast RC oscillator,
the main crystal oscillator or the PLLA. The power management controller can be used to adapt
the frequency and to disable the peripheral clocks.
5.5 Low-Power Modes
The various low-power modes of the SAM4S are described below:
5.5.1
Backup Mode
The purpose of backup mode is to achieve the lowest power consumption possible in a system
which is performing periodic wake-ups to perform tasks but not requiring fast startup time. Total
current consumption is 1 µA typical (VDDIO = 1.8V to 25°C).
The Supply Controller, zero-power power-on reset, RTT, RTC, Backup registers and 32 kHz
oscillator (RC or crystal oscillator selected by software in the Supply Controller) are running. The
regulator and the core supply are off.
Backup mode is based on the Cortex-M4 deep sleep mode with the voltage regulator disabled.
The SAM4S can be awakened from this mode through WUP0-15 pins, the supply monitor (SM),
the RTT or RTC wake-up event.
Backup mode is entered by writing the Supply Controller Control Register (SUPC_CR) with the
VROFF bit at 1 (a key is needed to write the VROFF bit, please refer to the “Supply Controller
(SUPC)” section of the product datasheet) and with the SLEEPDEEP bit in the Cortex-M4 Sys-
tem Control Register set to 1. (See the Power management description in the “ARM Cortex-M4
Processor” section of the product datasheet).
21
11100BS–ATARM–31-Jul-12

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]