SC1189 查看數據表（PDF） - Semtech Corporation

零件编号

产品描述 (功能)

生产厂家

SC1189

Programmable Synchronous DC/DC Converter, Dual LDO Controller

Semtech Corporation 

SC1189

POWER MANAGEMENT

Layout Guidelines (Cont.)

4) The Output Capacitor(s) (Cout) should be located as

close to the load as possible, fast transient load currents

are supplied by Cout only, and connections between Cout

and the load must be short, wide copper areas to mini-

mize inductance and resistance.

5) The SC1189 is best placed over a quiet ground plane

area, avoid pulse currents in the Cin, Q1, Q2 loop flowing

in this area. PGNDH and PGNDL should be returned to

the ground plane close to the package. The AGND pin

should be connected to the ground side of (one of) the

output capacitor(s). If this is not possible, the AGND pin

may be connected to the ground path between the Output

Capacitor(s) and the Cin, Q1, Q2 loop. Under no circum-

stances should AGND be returned to a ground inside the

Cin, Q1, Q2 loop.

6) Vcc for the SC1189 should be supplied from the 5V

supply through a 10Ω resistor, the Vcc pin should be

decoupled directly to AGND by a 0.1µF ceramic capacitor,

trace lengths should be as short as possible.

7) The Current Sense resistor and the divider across it

should form as small a loop as possible, the traces run-

ning back to CS+ and CS- on the SC1189 should run par-

allel and close to each other. The 0.1µF capacitor should

be mounted as close to the CS+ and CS- pins as possible.

8) Ideally, the grounds for the two LDO sections should be

returned to the ground side of (one of) the output

capacitor(s).

5V

Currents in Power Section

+

Vout

+

 2007 Semtech Corp.

8

www.semtech.com

Share Link: