SC9244 查看數據表（PDF） - Silan Microelectronics

零件编号

产品描述 (功能)

生产厂家

SC9244

REMOTE CONTROL TRANSMITTER OF 9012 CODE FORMAT

Silan Microelectronics 

SC9244

2. CODE TRANSMISSION

The transmitting code includes a lead code, 16-bit system code, 8-bit data code and 8-bit b1s complement of

data code.

The lead code is composed of 4.5ms high level and 4.5ms low level, thus 9ms in total, and it is used as the

leader for the following codes. Thus, when reception is configured by a microcomputer, it will time the various

operations such as decoding. The code uses the PPM (Pulse Phase Modulation) Method, with “0”and “1”

differentiated by the time between pulses.

3. REMOTE OUTPUT WAVEFORM

DOUT Output waveform

Press

the key

About 38ms

Data transmission waveform about

108ms

Successive transmission waveform

about 108ms

Data transmission waveform

Lead code

System code

System code

Key data code

B1s complement of

key data code

9ms

17.92ms~36ms

01

1

01

4.5ms

4.5ms

9ms

1.125ms 2.25ms

0.56ms

Successive transmission waveform

0.56ms

27ms

4.5ms

4.5ms

9ms

Carrier waveform

0.56ms

2.25ms

When S0( System code BIT0)=0, this bit transmits 1

2/3

1/3

38KHz

When oscillation frequency is 455 KHz, the output signal is modulated by 38 KHz of duty 1/3 (which is 1/12 of

the carrier generation circuit).

Note: In designing the firmware of the receiving and decoding circuit, please strictly follow the following

instructions:

1) System Codes: The same code is transmitted twice and therefore, and then decodes system codes for

two times and check if they are in agreement with each other.

2) Key Data Codes: The Key Data Code and its inversed code are always transmitted together, therefore,

check if they are in agreement with each other.

HANGZHOU SILAN MICROELECTRONICS CO.,LTD

Http: www.silan.com.cn

REV:1.0 2006.04.24

Page 4 of 11

Share Link: