ADP3308ART-3 查看數據表（PDF） - Analog Devices

零件编号

产品描述 (功能)

生产厂家

ADP3308ART-3

anyCAP® 50 mA Low Dropout Linear Regulator

Analog Devices 

ADP3308

The following general guidelines will be helpful when designing

a board layout:

1. PC board traces with larger cross section areas will remove

more heat. For optimum results, use PC boards with thicker

copper and or wider traces.

2. Increase the surface area exposed to open air so heat can be

removed by convection or forced air flow.

3. Do not use solder mask or silk screen on the heat dissipating

traces because it will increase the junction to ambient thermal

resistance of the package.

Shutdown Mode

Applying a TTL high signal to the shutdown pin or tying it to

the input pin will turn the output ON. Pulling the shutdown pin

down to a TTL low signal or tying it to ground will turn the

output OFF. In shutdown mode, quiescent current is reduced

to less than 1 µA.

APPLICATION CIRCUITS

Crossover Switch

The circuit in Figure 3 shows that two ADP3308s can be used

to form a mixed supply voltage system. The output switches

between two different levels selected by an external digital input.

Output voltages can be any combination of voltages from the

Ordering Guide of the data sheet.

Higher Output Current

The ADP3308 can source up to 50 mA without any heatsink or

pass transistor. If higher current is needed, an appropriate pass

transistor can be used, as in Figure 4, to increase the output

current to 1 A.

VIN = 4V TO 8V

C1

47␮F

MJE253*

R1

50⍀

VOUT = 3.0V @ 1A

IN

OUT

ADP3308-3.0

SD

GND

C2

10␮F

*AAVID531002 HEAT SINK IS USED

Figure 4. Higher Output Current Linear Regulator

Constant Dropout Post Regulator

The circuit in Figure 5 provides high precision with low dropout

for any regulated output voltage. It significantly reduces the ripple

from a switching regulator while providing a constant dropout

voltage, which limits the power dissipation of the LDO to 30 mW.

The ADP3000 used in this circuit is a switching regulator in the

step-up configuration.

VIN = 4V TO 12V

OUTPUT SELECT

4V

0V

IN

OUT

ADP3308-3.0

SD

GND

VOUT = 3.0V/3.3V

C1

1.0␮F

IN

OUT

ADP3308-3.3

SD GND

C2

0.47␮F

Figure 3. Crossover Switch

VIN = 2.5V TO 3.5V

L1

6.8␮H

C1

100␮F

10V

R1

120⍀

ILIM

VIN SW1

ADP3000-ADJ

GND

FB

SW2

D1

1N5817

C2

100␮F

10V

R2

30.1k⍀

1%

Q1

2N3906

R3

124k⍀

1%

ADP3308-3.0

IN

OUT

SD

GND

3.0V@50mA

C3

2.2␮F

Q2

2N3906

R4

274k⍀

Figure 5. Constant Dropout Post Regulator

REV. B

–7–

Share Link: