SSC2127 查看數據表（PDF） - Secos Corporation.

零件编号

产品描述 (功能)

生产厂家

SSC2127

750mA CMOS Positive Voltage Regulator

Secos Corporation. 

Elektronische Bauelemente

SSC2127

750mA CMOS

Positive Voltage Regulator

Ordering Information(contd.)

Part Number

SSC2127-15

SSC2127-25

Marking

7B152

XXXX

7B252

XXXX

Output Voltage

1.5V

2.5V

Part Number

SSC2127-18

SSC2127-33

Marking

7B182

XXXX

7B332

XXXX

Output Voltage

1.8V

3.3V

Detailed Description

The SSC2127 of COMS regulators contain a PMOS pass transistor,voltage reference, error amplifier,over-current protection and thermal

shutdown.The P-channel pass transistor receives data from the error amplifier, over-current shutdown, and thermal protection circuits.

During normal operation, the error amplifier compares the output voltage to a precision reference. Over-current and Thermal shutdown circuits

become active when the junction temperature exceeds140oC, or the current exceeds 2.2A.During thermal shutdown, the output voltage

remains low. Normal operation is restored when the junction temperature drops below 120oC.The SSC2127 behaves like a current

source when the load reaches 2.2A. However, if the load impedance drops below 0.3 Ω , the current drops back to 600mA to prevent

excessive power dissipation. Normal operation is restored when the load resistance exceeds of 0.75 Ω .

External Capacitors

The SSC2127 is stable with an output capacitance to ground of 4.7uF or greater. Ceramic capacitors have the lowest ESR, and will

offer the best AC performance. Conversely, Aluminum Electrolytic capacitors exhibit the highest ESR, resulting in the poorest AC

response. Unfortunately, large value ceramic capacitors are comparatively expensive. One option is to parallel a 0.1uF ceramic

capacitor with a 10uF Aluminum Electrolytic. The benefit is low ESR, high capacitance, and low overall cost. A second capacitor is

recommended between the input and ground to stabilize VIN. The input capacitor should be at least 0.1uF to have a beneficial

effect. All capacitors should be placed in closed proximity to the pins. A "Quiet" ground termination is desirable. This can be

achieved with a "Star" connection.

Enable

When EN pin is pulled low, the PMOS pass transistor shuts off, and all internal circuits are powered down. In this state, the quiescent

current is less than 2uA. This pin behaves much like an electronic switch. 100KΩ resistor is necessary between VEN source and EN

pin when VEN is high than VIN. (Note: There is no internal pull-up for EN pin. It can not be floating.)

Power Good

The SSC2127 includes the Power Good feature. When the output in not within

occur under the following conditions:

1. Input voltage too low.

2. During over-temperature.

3. During over-current.

4. If output is pulled up.

( Note: PG pin is an open-drain output.)

± 15% of the specified voltage, it pulls low. This can

ht tp://www.SeCoSGmbH.com/

01-Jun-2002 Rev. A

Any changing of specification will not be informed individual

Page 3 of 6

Share Link: