ST8016 查看數據表（PDF） - Sitronix Technology Co., Ltd.
零件编号
产品描述 (功能)
生产厂家
ST8016 Datasheet PDF : 28 Pages
| |||
5 BLOCK DIAGRAM
V0R
V12R
V43R
Y1
Y2
Y159 Y160
FR
DISPOFF
EIO1
EIO2
LP
XCK
L/R
MD
S/C
LEVEL
SHIFTER
ACTIVE
CONTROL
CONTROL LOGIC
8
160-BIT 4-LEVEL DRIVER
160
160-BIT LEVEL SHIFTER
160
160-BIT LINE LATCH/SHIFT REGISTER
16 16
16
8 BIT
DATA
LATCH
DATA LATCH CONTROL
SP CONVERSION & DATA CONTROL
(4 to 8 or 8 to 8)
DI0 DI1 DI2 DI3 DI4 DI5 DI6 DI7
VDD
VSS
ST8016
V43L
V12L
V0L
6 FUNCTIONAL OPERATIONS OF EACH BLOCK
BLOCK
FUNCTION
In case of segment mode, controls the selection or non-selection of the chip.
Following an LP signal input, and after the chip selection signal is input, a selection signal
Active Control
is generated internally until 160 bits of data have been read in.
Once data input has been completed, a selection signal for cascade connection is output,
and the chip is non-selected.
In case of common mode, controls the input/output data of bi-directional pins.
SP Conversion
& Data Control
In case of segment mode, keeps input data which are 2 clocks of XCK at 4-bit parallel
input mode in latch circuit, or keeps input data which are 1 clock of XCK at 8-bit parallel
input mode in latch circuit; after that they are put on the internal data bus 8 bits at a time.
In case of segment mode, selects the state of the data latch which reads in the data bus
Data Latch Control signals. The shift direction is controlled by the control logic. For every 16 bits of data read
in, the selection signal shifts one bit based on the state of the control circuit.
In case of segment mode, latches the data on the data bus. The latch state of each LCD
Data Latch
drive output pin is controlled by the control logic and the data latch control; 160 bits of
data are read in 20 sets of 8 bits.
In case of segment mode, all 160 bits which have been read into the data latch are
Line Latch/
simultaneously latched at the falling edge of the LP signal, and are output to the level
Shift Register
shifter block. In case of common mode, shifts data from the data input pin at the falling
edge of the LP signal.
Level Shifter
The logic voltage signal is level-shifted to the LCD drive voltage level, and is output to the
driver block.
4-Level Driver
Drives the LCD drive output pins from the line latch/shift register data, and selects one of
4 levels (V0, V12, V43 or VSS) based on the S/C, FR and /DISPOFF signals.
Controls the operation of each block. In case of segment mode, when an LP signal has
been input, all blocks are reset and the control logic waits for the selection signal output
Control Logic
from the active control block. Once the selection signal has been output, operation of the
data latch and data transmission is controlled, 160 bits of data are read in, and the chip is
non-selected. In case of common mode, controls the direction of data shift.
Ver 2.0
Page 4/28
2008/05/07
Share Link: 