Philips Semiconductors
Light position controller
Product specification
TDA3629
Notes to the characteristics
1. Steady state implies that the motor is not running (Im = 0) and VSET = VFB = 0.5VP.
2. This is only valid when the temperature protection is not active.
3. ∆VSET is the difference in voltage on the set potentiometer between the situation when the ground wire is interrupted
(VSET, br) and voltage on the set potentiometer during normal operation (when VSET = 0.17Vb = 2.72 V).
The conditions for this test are:
RSET = 20 kΩ; Vb = 16 V; ∆VSET = VSET, br − 2.72 V; see Fig.6.
handbook, halfpage
+Vb
830 Ω
390 Ω
battery
REMAINDER OF
MODULE
170 Ω
+
VSET, br
RSET
ground
−
ground wire not connected
MGE637
The 170 Ω, 830 Ω and 390 Ω resistors form the setting potentiometer in its worst case position. The given situation (combination of Vb, RSET and the
position of the set potentiometer) forms the worst case situation. The given maximum of ∆VSET guarantees that any other module, connected to the
same set potentiometer, will not start to activate its motor, when its motor switch-on level is higher than 0.01Vb (RSET ≥ 20 kΩ).
Fig.6 Conditions for the test of note 3.
QUALITY SPECIFICATION
The quality of this device is in accordance with “SNW-FQ-611 part E”. The numbers of the quality specification can be
found in the “Quality reference Handbook”. The handbook can be ordered using the code 9397 750 00192.
1996 Sep 04
9