TDA7388A 查看數據表（PDF） - STMicroelectronics
零件编号
产品描述 (功能)
生产厂家
TDA7388A Datasheet PDF : 13 Pages
| |||
Application hints
3
Application hints
TDA7388A
Ref. to the circuit of Figure 2.
3.1
SVR
Besides its contribution to the ripple rejection, the SVR capacitor governs the turn ON/OFF
time sequence and, consequently, plays an essential role in the pop optimization during
ON/OFF transients.
To conveniently serve both needs, ITS MINIMUM RECOMMENDED VALUE IS 10µF.
3.2
Input stage
The TDA7388A’s inputs are ground-compatible and can stand very high input signals (±
8Vpk) without any performances degradation.
If the standard value for the input capacitors (0.1µF) is adopted, the low frequency cut-off
will amount to 16 Hz.
3.3
Stand-by and Muting
Stand-by and Muting facilities are both 3.3V CMOS-COMPATIBLE. If unused, a straight
connection to Vs of their respective pins would be admissible.
Conventional/low-power transistors can be employed to drive muting and stand-by pins in
absence of true CMOS ports or microprocessors. R-C cells have always to be used in order
to smooth down the transitions for preventing any audible transient noises.
Since a DC current of about 10µA normally flows out of pin 23, the maximum allowable
muting-series resistance (R2) is 70KΩ, which is sufficiently high to permit a muting capacitor
reasonably small (about 1µF).
If R2 is higher than recommended, the involved risk will be that the voltage at pin 23 may rise
to above the 1.5V threshold voltage and the device will consequently fail to turn OFF when
the mute line is brought down.
About the stand-by, the time constant to be assigned in order to obtain a virtually pop-free
transition has to be slower than 2.5V/ms.
10/13
Share Link: 