TK15406M 查看數據表（PDF） - Toko America Inc
零件编号
产品描述 (功能)
生产厂家
TK15406M Datasheet PDF : 8 Pages
| |||
+Input
TP1
75 Ω
+
4.7 µF
TEST CIRCUIT
VCC
VCC = 5.0 V
33 µF
TP2
Output
VOUT = 2.0 VP-P
+
75 Ω
TP3
47 µF
75 Ω
TK15406
Standby
GND
MEASUREMENT METHOD
1. Supply Current (ICC)
The Pin 6 current is measured with no input signal and the Standby Pin (Pin 1) open.
2. Standby Supply Current (ISTBY)
The Pin 6 current is measured when the Standby Pin (Pin 1) is connected to ground.
3. Standby Terminal Current (IOS)
The Pin 1 current is measured when Pin 1 is connected to ground.
4. Threshold Voltage (High to Low) (V )
THL
The Pin 1 voltage is measured at the point which changes the device from operating mode into standby mode.
5. Threshold Voltage (Low to High) (VTLH)
The Pin 1 voltage is measured at the point which changes the device from standby mode into operating mode.
6. Bias Voltage (VBIAS)
The DC voltage at Pin 4 is measured with no input signal.
7. Voltage Gain (GVA)
The voltage gain equation is as follows:
GVA = 20 log V2/V1
10
Where V1 is the input voltage at TP1 and V2 is the measured output voltage at TP2.
8. Frequency Response (fr)
The frequency response equation is as follows:
fr = 20 log V2/V1
10
Where V1 is the measured TP3 voltage when the TP1 input frequency is set to 1 MHz and V2 is the measured TP3 voltage
when the TP1 input frequency is set to 5 MHz.
9. Total Harmonic Distortion (THD)
The TP3 signal is measured when a 1 kHz 1 VP-P input signal is applied to TP1.
10. Maximum Output Voltage (VOUT(MAX))
A 1 kHz input signal is applied to TP1 and the amplitude is slowly increased. The output voltage at TP2 is measured at
the point the THD reaches 10%.
January 2000 TOKO, Inc.
Page 3
Share Link: 