US4881(2006) 查看數據表（PDF） - Melexis Microelectronic Systems
零件编号
产品描述 (功能)
生产厂家
US4881
(Rev.:2006)
(Rev.:2006)
Melexis Microelectronic Systems
US4881 Datasheet PDF : 11 Pages
| |||
US4881
Bipolar Hall Switch
Low Voltage & Very High Sensitivity
12 Application Information
12.1 Typical Three-Wire Application Circuit
12.2 Two-Wire Circuit
12.3 Automotive and Harsh, Noisy Environments
Three-Wire Circuit
Note:
With this circuit, precise ON and OFF
currents can be detected using only two
connecting wires.
The resistors RL and Rb can be used to
bias the input current. Refer to the part
specifications for limiting values.
BRP : IOFF = IR + IDD = VDD/Rb + IDD
BOP : ION = IOFF + IOUT = IOFF + VDD/RL
13 Application Comments
For proper operation, a 100nF bypass capacitor should be placed as close as possible to the device between
the VDD and ground pin.
For reverse voltage protection, it is recommended to connect a resistor or a diode in series with the VDD pin.
When using a resistor, three points are important:
- the resistor has to limit the reverse current to 50mA maximum (VCC / R1 ≤ 50mA)
- the resulting device supply voltage VDD has to be higher than VDD min (VDD = VCC – R1.IDD)
- the resistor has to withstand the power dissipated in reverse voltage condition (PD = VCC2 / R1)
When using a diode, a reverse current cannot flow and the voltage drop is almost constant (≈0.7V).
Therefore, a 100Ω/0.25W resistor for 5V application and a diode for higher supply voltage are recommended.
Both solutions provide the required reverse voltage protection.
When a weak power supply is used or when the device is intended to be used in noisy environment, it is
recommended that figure 13.3 from the Application Information section is used.
The low-pass filter formed by R1 and C1 and the zener diode Z1 bypass the disturbances or voltage spikes
occurring on the device supply voltage VDD. The diode D1 provides additional reverse voltage protection.
3901004881
Rev 011
Page 7 of 11
Data Sheet
Feb/06
Share Link: