MSM82C54-2GS-K 查看數據表（PDF） - Oki Electric Industry

零件编号

产品描述 (功能)

生产厂家

MSM82C54-2GS-K

CMOS PROGRAMMABLE INTERVAL TIMER

Oki Electric Industry 

¡ Semiconductor

MSM82C54-2RS/GS/JS

• Select Counter (SC0, SC1): Selection of set counter

SC1 SC0

Set Contents

0

0 Counter #0 selection

0

1 Counter #1 selection

1

0 Counter #2 selection

1

1 Read Back Command

• Read/Load (RL1, RL0): Count value Reading/Loading format setting

RL1 RL0

0

0

0

1

1

0

1

1

Set Contents

Counter Latch Operation

Reading/Loading of Least Significant Byte (LSB)

Reading/Loading of Most Significant Byte (MSB)

Reading/Loading of LSB followed by MSB

• Mode (M2, M1, M0): Operation waveform mode setting

M2 M1 M0

Set Contents

0

0

0

Mode 0 (Interruput on Terminal Count)

0

0

1

Mode 1 (Programmable One-Shot)

¥

1

0

Mode 2 (Rate Generator)

¥

1

1

Mode 3 (Square Wave Generator)

1

0

0

Mode 4 (Software Triggered Strobe)

1

0

1

Mode 5 (Hardware Triggered Strobe)

¥: denotes "not specified"

• BCD: Operation count mode setting

BCD

Set Contents

0 Binary Count (16-bit Binary)

1 BCD Count (4-decade Binary Coded Decimal)

After setting Read/Load, Mode and BCD in each counter as outlined above, next set the desired

count value. (In some Modes, the count value is set first. In next clock, loading is performed,

then counting starts.) This count value setting must conform with the Read/Load format set

in advance. Note that the internal counters are reset to 0000H during control word setting. The

counter value (0000H) can’t be read.

The program sequence of the MSM82C54-2 is flexible.

Free sequence programming is possible as long as the two following rules are observed:

(i) Write the control word before writing the initial count value in each counter.

(ii) Write the initial count value according to the count value read/write format specified by the

control word.

Note: Unlike the MSM82C53-2, the MSM82C54-2 allows count value setting for another

counter between LSB and MSB settings.

9/23

Share Link: