TS80C51RA2-ECAB 查看數據表（PDF） - Atmel Corporation

零件编号

产品描述 (功能)

生产厂家

TS80C51RA2-ECAB

High Performance 8-bit Microcontrollers

Atmel Corporation 

TS80C51RA2/RD2

TS83C51RB2/RC2/RD2

TS87C51RB2/RC2/RD2

Mnemonic

ALE/PROG

Pin Number

30 33

27

PSEN

29 32

26

EA/VPP

31 35

29

XTAL1

XTAL2

19 21

15

18 20

14

Type

Name And Function

O (I)

O

I

I

Address Latch Enable/Program Pulse: Output pulse for latching the low byte

of the address during an access to external memory. In normal operation, ALE

is emitted at a constant rate of 1/6 (1/3 in X2 mode) the oscillator frequency,

and can be used for external timing or clocking. Note that one ALE pulse is

skipped during each access to external data memory. This pin is also the program

pulse input (PROG) during EPROM programming. ALE can be disabled by

setting SFR’s AUXR.0 bit. With this bit set, ALE will be inactive during internal

fetches.

Program Store ENable: The read strobe to external program memory. When

executing code from the external program memory, PSEN is activated twice each

machine cycle, except that two PSEN activations are skipped during each access

to external data memory. PSEN is not activated during fetches from internal

program memory.

External Access Enable/Programming Supply Voltage: EA must be externally

held low to enable the device to fetch code from external program memory

locations 0000H and 3FFFH (RB) or 7FFFH (RC), or FFFFH (RD). If EA is

held high, the device executes from internal program memory unless the program

counter contains an address greater than 3FFFH (RB) or 7FFFH (RC) EA must

be held low for ROMless devices. This pin also receives the 12.75V programming

supply voltage (VPP) during EPROM programming. If security level 1 is

programmed, EA will be internally latched on Reset.

Crystal 1: Input to the inverting oscillator amplifier and input to the internal

clock generator circuits.

O Crystal 2: Output from the inverting oscillator amplifier

8

Rev. C - 06 March, 2001

Share Link: