UDK2549 查看數據表（PDF） - Allegro MicroSystems

零件编号

产品描述 (功能)

生产厂家

UDK2549

PROTECTED QUAD POWER DRIVER

Allegro MicroSystems 

2549

PROTECTED

QUAD POWER DRIVER

TYPICAL OUTPUT

CHARACTERISTIC

TJ < 150°C

NOT TO SCALE

T = 165°C

J

JUNCTION

TEMP. LIMIT

V OUT(SAT)

THERMAL

GRADIENT

SENSING

I TRIP

OUTPUT CURRENT, I OUT

Dwg. GP-013

TYPICAL OUTPUT BEHAVIOR

NORMAL LAMP IN-RUSH CURRENT

NOT TO SCALE

THERMAL GRADIENT SENSING

CURRENT LIMIT

ITRIP

0

TIME

Dwg. WP-008

CIRCUIT DESCRIPTION AND APPLICATION

INCANDESCENT LAMP DRIVER

High incandescent lamp turn-ON/in-rush currents can contribute to

poor lamp reliability and destroy semiconductor lamp drivers. Warming

or current-limiting resistors protect both driver and lamp but use signifi-

cant power either when the lamp is OFF or when the lamp is ON,

respectively. Lamps with steady-state current ratings up to 600 mA

can be driven by these devices without the need for warming (parallel)

or current-limiting (series) resistors.

When an incandescent lamp is initially turned ON, the cold filament

is at minimum resistance and would normally allow a 10x to 12x in-rush

current. With the these drivers, during turn-ON, the high in-rush current

is sensed by the internal low-value sense resistor. Drive current to the

output stage is then diverted by the shunting transistor, and the load

current is momentarily limited to approximately 1.0 A. During this short

transition period, the output current is reduced to a value dependent on

supply voltage and filament resistance. During lamp warmup, the

filament resistance increases to its maximum value, the output stage

goes into saturation and applies maximum rated voltage to the lamp.

INDUCTIVE LOAD DRIVER

Bifilar (unipolar) stepper motors, relays, or solenoids can be driven

directly. The internal flyback diodes prevent damage to the output

transistors by suppressing the high-voltage spikes which occur when

turning OFF an inductive load. For rapid current decay (fast turn-OFF

speeds), the use of Zener diodes will raise the flyback voltage and

improve performance. However, the peak voltage must not exceed the

specified minimum sustaining voltage (VSUPPLY + VZ + VF ≤ VOUT(SUS)).

FAULT CONDITIONS

In the event of a shorted load, the load current will attempt to

increase. As described above, the drive current to the affected output

stage is reduced, causing the output stage to go linear, limiting the peak

output current to approximately 1 A. As the power dissipation of that

output stage increases, a thermal gradient sensing circuit will become

operational, further decreasing the drive current to the affected output

stage and reducing the output current to a value dependent on supply

voltage and load resistance.

Continuous or multiple overload conditions causing the chip tem-

perature to reach approximately 165°C will result in an additional

reduction in output current to maintain a safe level.

If the fault condition is corrected, the output stage will return to its

normal saturated condition.

115 Northeast Cutoff, Box 15036

Worcester, Massachusetts 01615-0036 (508) 853-5000

Share Link: