UEI30-150-Q12P-C 查看數據表（PDF） - Murata Manufacturing
零件编号
产品描述 (功能)
生产厂家
UEI30-150-Q12P-C Datasheet PDF : 16 Pages
| |||
Negative: Models with negative polarity are on (enabled) when the On/Off is
grounded or brought to within a low voltage (see Specifications) with respect to
–VIN. The device is off (disabled) when the On/Off is left open or is pulled high
to +15VDC Max. with respect to –VIN.
Dynamic control of the On/Off function should be able to sink the speci-
fied signal current when brought low and withstand appropriate voltage
when brought high. Be aware too that there is a finite time in milliseconds
(see Specifications) between the time of On/Off Control activation and stable,
regulated output. This time will vary slightly with output load type and current
and input conditions.
There are two CAUTIONs for the On/Off Control:
CAUTION: While it is possible to control the On/Off with external logic if you
carefully observe the voltage levels, the preferred circuit is either an open
drain/open collector transistor or a relay (which can thereupon be controlled by
logic). The On/Off prefers to be set at approx. +15V (open pin) for the ON state,
assuming positive logic.
CAUTION: Do not apply voltages to the On/Off pin when there is no input
power voltage. Otherwise the converter may be permanently damaged.
UEI30 Series
30W Isolated Wide-Range DC/DC Converters
3
ON/OFF
CONTROL
1 -INPUT
+VCC
Figure 7 – Driving the On/Off Control Pin (suggested circuit)
On/Off Enable Control Ground Bounce Protection
To improve reliability, if you use a small signal transistor or other external
circuit to select the Remote On/Off control, make sure to return the LO side
directly to the –Vin power input on the DC/DC converter. To avoid ground
bounce errors, do not connect the On/Off return to a distant ground plane or
current-carrying bus. If necessary, run a separate small return wire directly to
the –Vin terminal. There is very little current (typically 1-5 mA) on the On/Off
control however, large current changes on a return ground plane or ground bus
can accidentally trigger the converter on or off. If possible, mount the On/Off
transistor or other control circuit adjacent to the converter.
On/Off
Control
Transistor
Preferred location
of On/Off control
adjacent to -Vin
terminal
DC/DC Converter
+ Vin
On/Off Enable
-Vin return
Do not connect
control transistor
through remote
power bus
Ground plane or power return bus
Install separate
return wire for
On/Off control
with remote
transistor
Figure 8 – On/Off Enable Control Ground Bounce Protection
www.murata-ps.com
email: sales@murata-ps.com
03 Feb 2011 MDC_UEI Series 30W.A14 Page 9 of 16
Share Link: 