µPD780053, 780054, 780055, 780056, 780058
3. PIN FUNCTIONS
3.1 PORT PINS (1/2)
Pin Name
P00
P01
P02
P03
P04
P05
P07Note 1
P10-P17
I/O
Input
Input/
output
Input
Input/
output
P20
P21
P22
P23
P24
P25
P26
P27
P30
P31
P32
P33
P34
P35
P36
P37
P40-P47
Input/
output
Input/
output
Input/
output
Port 0
7-bit input/output port
Function
Input only
Input/output can be specified bit-wise.
When used as an input port, on-chip pull-up
resistor can be used by software.
Input only
Port 1
8-bit input/output port.
Input/output can be specified bit-wise.
When used as an input port, on-chip pull-up resistor can be used by
softwareNote 2.
Port 2
8-bit input/output port.
Input/output can be specified bit-wise.
When used as an input port, on-chip pull-up resistor can be used by
software.
Port 3
8-bit input/output port.
Input/output can be specified bit-wise.
When used as an input port, on-chip pull-up resistor can be used by
software.
Port 4
8-bit input/output port.
Input/output can be specified in 8-bit unit.
When used as an input port, on-chip pull-up resistor can be used by
software. Test input flag (KRIF) is set to 1 by falling edge detection.
After
Dual-
Reset Function Pin
Input INTP0/TI00
Input INTP1/TI01
INTP2
INTP3
INTP4
INTP5
Input
XT1
Input ANI0-ANI7
Input
Input
Input
SI1
SO1
SCK1
STB/TxD1
BUSY/RxD1
SI0/SB0
SO0/SB1
SCK0
TO0
TO1
TO2
TI1
TI2
PCL
BUZ
—
AD0-AD7
Notes 1. When using the P07/XT1 pins as an input port, set 1 in the bit 6 (FRC) of the processor clock control
register (PCC). On-chip feedback resistor of the subsystem clock oscillator should not be used.
2. When using the P10/ANI0 to P17/ANI7 pins as the A/D converter analog input pins, set port 1 to input
mode. Use of the on-chip pull-up resistor is cancelled automatically.
10
Preliminary Data Sheet