VSC7133QU 查看數據表（PDF） - Vitesse Semiconductor

零件编号

产品描述 (功能)

生产厂家

VSC7133QU

10-bit Transceiver for Fibre Channel and Gigabit Ethernet

Vitesse Semiconductor 

VITESSE

SEMICONDUCTOR CORPORATION

10-bit Transceiver for Fibre

Channel and Gigabit Ethernet

Advance Product Information

VSC7133

Functional Description

Clock Synthesizer

The VSC7133 clock synthesizer multiplies the reference frequency provided on the REFCLK pin by 10 to

achieve a baud rate clock between 0.98 and 1.36 GHz. The on-chip PLL uses a single external 0.1uF capacitor

to control the Loop Filter. The REFCLK is either TTL or LV PECL. If TTL, connect the TTL input to

REFLKP and leave REFCLKN open, it is biased for a TTL switch level. If PECL, connect both REFCLKP and

REFCLKN.

Serializer

The VSC7133 accepts TTL input data as a parallel 10 bit character on the T(0:9) bus, which is latched into

the input register on the rising edge of REFCLK. This data is serialized and transmitted on the TX PECL differ-

ential outputs at a baud rate that is ten times the frequency of the REFCLK, with bit T0 transmitted first. User

data should be encoded using 8B/10B block code or equivalent.

Transmission Character Interface

An encoded byte is 10 bits and is referred to as a transmission character. The 10 bit interface on the

VSC7133 corresponds to a transmission character. This mapping is illustrated in Figure 1.

Figure 1: Transmission Order and Mapping of an 8B/10B Character

Parallel Data Bits

8B/10B Bit Position

Comma Character

T9 T8 T7 T6 T5 T4 T3 T2 T1 T0

j hgf i edcba

XXX1 1 1 1 1 0 0

Last Data Bit Transmitted

First Data Bit Transmitted

Clock Recovery

The VSC7133 accepts differential high speed serial inputs on the RX+/RX- pins, extracts the clock and

retimes the data. Equalizers are included in the receiver to open the data eye and compensate for InterSymbol

Interference (ISI) which may be present in the incoming data. The serial bit stream should be encoded so as to

provide DC balance and limited run length by an 8B/10B encoding scheme. The Clock Recovery Unit (CRU) is

completely monolithic and requires no external components. For proper operation, the baud rate of the data

stream to be recovered should be within +200 ppm of ten times the REFCLK frequency. For example, Gigabit

Ethernet systems would use 125 MHz oscillators with a +/-100ppm accuracy resulting in +/-200 ppm between

VSC7133 pairs.

Page 2

© VITESSE SEMICONDUCTOR CORPORATION

741 Calle Plano, Camarillo, CA 93012 • 805/388-3700 • FAX: 805/987-5896

G52187-0 Rev. 2.4

1/17/00

Share Link: