VSC8150QQ 查看數據表（PDF） - Vitesse Semiconductor
零件编号
产品描述 (功能)
生产厂家
VSC8150QQ Datasheet PDF : 20 Pages
| |||
VITESSE
SEMICONDUCTOR CORPORATION
Preliminary Data Sheet
VSC8150
2.488Gb/s SONET/SDH
Overhead Monitor
Figure 3: Suggested VSC8150 System Implementation
VSC8150
B1ERR
RXFPOUT
SOHCLK
SOHOUT[7:0]
RXSEF
RXLOF
RXFRERR
FPGA
4 Bit Counter
RESET Q[2:0]
OAM&P
B1 Count
Frame Count
RESET
Q4
5 Bit Counter
B1 Valid
WA[4:0]
D[7:0]
RA[4:0]
Q[7:0]
27x8 Register File
OH Data
LOS
System Clock
High Speed Interface
Serial data received on the RXSIN+/- inputs is retimed on the falling edge of RXSCLKIN+/- clock and
appears on the serial loopback output RXSLBOUT+/- (See Figure 11). This interface will pass data at all fre-
quencies from DC to 2.5GHz, and does not necessarily have to retime SONET/SDH data.
Inputs RXSIN+/- and RXSCLKIN+/- do not have internal termination resistors, but internal biasing resis-
tors provide a bias voltage suitable for AC coupling (See Figure 4).
In most situations these inputs will have high transition density and little DC offset. However, in cases
where this does not hold, direct DC connection is possible. All serial data and clock inputs have the same cir-
cuit topology, as shown in figure 4. The reference voltage is created by a resistor divider as shown. If the input
signal is driven differentially and DC-coupled to the part, the mid-point of the input signal swing should be cen-
tered about this reference voltage and not exceed the maximum allowable amplitude. For single-ended, DC-
coupling operations, it is recommended that the user provides an external reference voltage which has better
temperature and power supply noise rejection than the on-chip resistor divider. The external reference should
have a nominal value equivalent to the common mode switch point of the DC coupled signal, and can be con-
nected to either side of the differential gate.
G52186-0, Rev. 3.0
10/12/98
© VITESSE SEMICONDUCTOR CORPORATION
741 Calle Plano, Camarillo, CA 93012 • 805/388-3700 • FAX: 805/987-5896
Page 5
Share Link: 