HT9170B(1999) 查看數據表（PDF） - Holtek Semiconductor

零件编号

产品描述 (功能)

生产厂家

HT9170B
(Rev.:1999)

DTMF Receiver

Holtek Semiconductor 

HT9170

Pin Description

Pin Name I/O

Internal

Connection

Description

VP

I

OPERATIONAL

AMPLIFIER

Operational amplifier non-inverting input

VN

I

Operational amplifier inverting input

GS

O

Operational amplifier output terminal

VREF

X1

X2

O

VREF

Reference voltage output, normally VDD/2

I

The system oscillator consists of an inverter, a bias resistor

O

OSCILLATOR

and the necessary load capacitor on chip.

A standard 3.579545MHz crystal connected to X1 and X2 ter-

minals implements the oscillator function.

PWDN

I

CMOS IN

Pull-low

Active high. This enables the device to go into power down

mode and inhibits the oscillator. This pin input is internally

pulled down.

INH

I

CMOS IN

Pull-low

Logic high. This inhibits the detection of tones representing

characters A, B, C and D. This pin input is internally pulled

down.

VSS

¾

¾

Negative power supply

OE

I

CMOS IN

Pull-high

D0~D3 output enable, high active

D0~D3

O

CMOS OUT

Tristate

Receiving data output terminals

OE=²H²: Output enable

OE=²L²: High impedance

Data valid output

DV

O CMOS OUT When the chip receives a valid tone (DTMF) signal, the DV

goes high; otherwise it remains low.

EST

O CMOS OUT Early steering output (see Functional Description)

RT/GT

I/O

CMOS IN/OUT

Tone acquisition time and release time can be set through

connection with external resistor and capacitor.

VDD

¾

¾

Positive power supply, 2.5V~5.5V for normal operation

DVB

One-shot type data valid output, normal high, when the chip

O CMOS OUT receives a valid time (DTMF) signal, the DVB goes low for

10ms.

3

December 20, 1999

Share Link: