AJAV-5501 查看數據表（PDF） - Avago Technologies
零件编号
产品描述 (功能)
生产厂家
AJAV-5501 Datasheet PDF : 6 Pages
| |||
Table 4. Electrical Specifications [1]
Parameter
Symbol Condition
Min Typ Max Unit
Frequency
Maximum Linear Output Power [2]
FRF
PMAX
HP mode
MP mode
1920 -
1980 MHz
+26.0 +26.5 -
dBm
+16.0 +16.5 -
dBm
Gain [2]
LP mode
G
HP mode
+5.5 +6.0 -
dBm
27.0 28.5 -
dB
MP mode
17.0 18.5 -
dB
RX Band Gain [2,3]
LP mode
GRX
RX Band, 190 MHz offset
GPS Band, 1524-1577 MHz
8.0
10.0 -
dB
-
-
-15
dBc
-
-
-35
dBc
Adjacent Channel Leakage Ratio [2,4] ACLR1
ISM Band, 2400-2484 MHz
± 5 MHz offset
-
-
-34
dBc
-
-42
-38
dBc
Noise [4,5]
ACLR2
N
± 10 MHz offset
RX Band, 190 MHz offset
-
-53
-48
dBc
-
-148 -
dBm/Hz
GPS Band, 1524-1577 MHz
-
-154 -
dBm/Hz
Error Vector Magnitude [2,4,5]
Power Added Efficiency [2,5,6]
ISM Band, 2400-2484 MHz
EVM
POUT ≤ PMAX
PAE
HP mode
-
-156 -
dBm/Hz
-
1.5
3.35 %
-
38
-
%
MP mode
-
23
-
%
Quiescent Idle Current
Average Current [2,5,7]
Powerdown Current [4,8]
Logic Current [4,9]
Input Impedance [5]
Reverse Intermodulation [4,5,10]
ICQ
IAVG
IPD
ICTRL
ZIN
LP mode
Total current from all pins
VEN = VIL
± 5 MHz offset
-
8
10
mA
-
26
-
mA
-
5
10
mA
-
7
10
mA
-
1.4:1 1.8:1 VSWR
-
-
-31
dBc
Harmonics [2,4,5]
Instantaneous Phase Change [4,5]
Coupling Factor [11]
Daisy Chain Insertion Loss [5]
2F0
3F0, 4F0
s31
s34
± 10 MHz offset
Second harmonic
Third and fourth harmonic
Between power modes
UMTS Band II
-
-
-41
dBc
-
-
-35
dBc
-
-
-35
dBc
-
5
10
degree
-
-19.5 -
dB
-
-0.4 -
dB
UMTS Band V, VIII
-
-0.2 -
dB
Daisy Chain Return Loss [5,11]
s33, s44 UMTS Band II
-
-18
-
dB
Output Power Error [5,12]
Turn-on Time [13]
Turn-off Time [5,13]
Other Spurious [4,5]
Ruggedness [5]
UMTS Band V, VIII
-
Load VSWR = 2.5:1
-1
TON
-
TOFF
-
Load VSWR ≤ 5:1
-
No permanent damage or degradation -
-27
-
dB
-
+1
dB
9
12
ms
7
10
ms
-
-70
dBc
-
10:1 VSWR
Notes:
1. Specifications at nominal operating conditions VIH = 1.8 V, VEN = 1.8 V, VBAT = 3.8 V, TA = 25 °C, RF ports at 50 Ω, guaranteed over the full range of
operating frequency and guaranteed by production test unless indicated otherwise.
2. Specification is guaranteed using W-CDMA modulation RMC (12.2 kbps) in compliance with 3GPP Release 99.
3. RX band gain is specified relative to PA gain at 1880 MHz.
4. Specification is guaranteed over all power modes given in Table 3.
5. Specification is guaranteed by characterization.
6. Power added efficiency (PAE) includes total current consumption through all pins while PA is operating at maximum linear output power.
7. Calculated using three power modes (HP, MP, LP) with handset WCDMA transmitter power distribution in GSMA DG.09 specification assuming 3 dB
of post-PA loss.
8. Total supply current measured when the PA is disabled.
9. Specification applies to each VEN, VM0, and VM1 pin.
10. Interferer is CW at a relative power level of -40 dBc and offset from the W-CDMA modulated carrier.
11. Measured at CPLO pin.
12. Power variation measured at the RFO pin while power at CPLO pin is held constant.
13. Specified from the start of the PA enable transition to when the output power is within ±1 dB of final value.
3
Share Link: 