DS18S20 查看數據表（PDF） - Maxim Integrated

零件编号

产品描述 (功能)

生产厂家

DS18S20

High-Precision 1-Wire Digital Thermometer

Maxim Integrated 

DS18S20

1-WIRE BUS SYSTEM

The 1-Wire bus system uses a single bus master to control one or more slave devices. The DS18S20 is

always a slave. When there is only one slave on the bus, the system is referred to as a “single-drop”

system; the system is “multidrop” if there are multiple slaves on the bus.

All data and commands are transmitted least significant bit first over the 1-Wire bus.

The following discussion of the 1-Wire bus system is broken down into three topics: hardware

configuration, transaction sequence, and 1-Wire signaling (signal types and timing).

HARDWARE CONFIGURATION

The 1-Wire bus has by definition only a single data line. Each device (master or slave) interfaces to the

data line via an open drain or 3-state port. This allows each device to “release” the data line when the

device is not transmitting data so the bus is available for use by another device. The 1-Wire port of the

DS18S20 (the DQ pin) is open drain with an internal circuit equivalent to that shown in Figure 9.

The 1-Wire bus requires an external pullup resistor of approximately 5kΩ; thus, the idle state for the

1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus MUST be left in the idle

state if the transaction is to resume. Infinite recovery time can occur between bits so long as the 1-Wire

bus is in the inactive (high) state during the recovery period. If the bus is held low for more than 480µs,

all components on the bus will be reset.

Figure 9. Hardware Configuration

VPU

DS18S20 1-Wire PORT

4.7k

DQ

1-Wire BUS

PIN

Rx

Rx

5μA

TYP

TX

Tx

Rx = RECEIVE

Tx = TRANSMIT

100Ω

MOSFET

9 of 23

Share Link: