LM4040B25H5TA 查看數據表（PDF） - Diodes Incorporated.
零件编号
产品描述 (功能)
生产厂家
LM4040B25H5TA Datasheet PDF : 12 Pages
| |||
LM4040
Application Information
In a conventional shunt regulator application (Figure 1), an external series resistor (RS) is connected between the supply voltage, VS, and the
LM4040.
VS
IR +
IL
RS
IL
VR
IR
RS determines the current that flows through the load (IL) and the LM4040 (IR). Since load current and supply voltage may
vary, RS should be small enough to supply at least the minimum acceptable IR to the LM4040 even when the supply voltage
is at its minimum and the load current is at its maximum value. When the supply voltage is at its maximum and IL is at its
minimum, RS should be large enough so that the current flowing through the LM4040 is less than 15mA.
RS is determined by the supply voltage, (VS), the load and operating current, (IL and IR), and the LM4040’s reverse
breakdown voltage, VR.
RS
VS
IL
VR
IR
Figure 1
Printed Circuit Board Layout Considerations
LM4040s in the SOT23 package have the die attached to pin 1, which results in an electrical contact between pin 2 and pin 3. Therefore, pin 1 of
the SOT23 package must be left floating or connected to pin 2.
LM4040s in the SC70-5 (Note 4) package have the die attached to pin 2, which results in an electrical contact between pin 2 and pin 1. Therefore,
pin 2 must be left floating or connected to pin 1.
Note:
4. SC70-5 variants are End of Life (EOL).
LM4040
Document number: DS33195 Rev. 7 - 2
8 of 12
www.diodes.com
February 2017
© Diodes Incorporated
Share Link: 