MCM69L817ZP6R 查看數據表（PDF） - Signal Processing Technologies

零件编号

产品描述 (功能)

生产厂家

MCM69L817ZP6R

S2ADC™ - Simultaneous Sampling Analog to Digital Converter

Signal Processing Technologies 

PIN ASSIGNMENTS

Pin 1-N.C.-No Connection

Pin 2-VIN B-Analog Input B

Pin 3-VIN A- Analog Input A

Pin 4-AGND-Analog Ground

Pin 5-VSS-Digital Ground

Pin 6-SCLK-Serial Clock Input

Pin 7-DOUT Digital Data Output

Pin 8-STATUS- High During Conversion

Pin 9-CS-Chip Select Bar Input High Deselects

chip Low Selects chip

Pin 10-SD-Shutdown Input, logic low power

up, logic high = powerdown

Pin 11-VDD Digital +5V supply

Pin 12-VDA Analog +5V supply

Pin 13-OffADJ-A External Offset Adjust A

Pin 14-OffADJ-B External Offset Adjust B

Pin 15-REFOUT-Voltage Reference Output

Pin 16-GAINADJ-External Gain Adjustment

N.C. 1

16 GAIN ADJUST

VIN B 2

15 REF OUT

VIN A 3

14 OFFSET ADJ. B

AGND 4

VSS 5

13 OFFSET ADJ. A

SP8530

12 VDA

SCLK 6

11 VDD

DOUT 7

10 PD

STATUS 8

9 CS

FEATURES

The SP8530 is a two channel simultaneous

sampling, 12-Bit serial out data acquisition

system. The device contains a high speed 12-bit

analog to digital converter, internal reference,

and sample and hold circuitry for both channels.

The patented, simultaneous sampling feature of

this monolithic integrated circuit, permits the

user to measure and convert the analog

information on each of two channels at the same

time, thus preserving the relevant temporal

information of the applied signals, precisely.

This unique feature permits the SP8530 to

ideally fit applications where the information

content is carried on dual carriers, such as

in-phase and quadrature phase systems.

Further, S2ADC™ architecture permits the

sampling of such signals without the necessity

of demodulating or further conditioning of the

carrier prior to conversion, potentially saving

significant amounts of other support electronics.

It is also suited to measure instantaneous

transfer functions between input signals and

their corresponding output signal.

Such measurements are commonly made in test

equipment and PIN electronics as well as in

many other systems where instantaneous cause

and effect relationships are monitored.

The SP8530 permits the user to convert each

channel and digitally subtract the result in

external logic to produce a precise digital

differential result.

The SP8530 is fabricated in Sipex' Bipolar

Enhanced CMOS Process that permits state-of-

the-art design using bipolar devices in the

analog/linear section and extremely low power

CMOS in digital/logic section.

CIRCUIT OPERATION

The operating circuit in Figure 1 shows a simple

circuit required to operate the SP8530. The

conversion is controlled by the user supplied

signal Chip Select Bar (CS) which selects and

deselects the device, and a system clock (SCLK).

A high level applied to CS asynchronously

clears the internal logic, puts the sample & hold

(CDAC) into sample mode and places the DOUT

(Data Output) pin in a high impedance state.

Conversion is initiated by falling edge on CS in

slave mode at which point the selected input

voltages are held and a conversion is started. A

delay of 90ns is required between the falling

edge of CS and the first rising of SCLK.

SP8530DS/01

SP8530 S2ADCTM - Simultaneous Sampling Analog to Digital Converter

5

© Copyright 2000 Sipex Corporation

Share Link: