MD82C55A-5/BZ 查看數據表（PDF） - Intersil
零件编号
产品描述 (功能)
生产厂家
MD82C55A-5/BZ Datasheet PDF : 30 Pages
| |||
82C55A
Pin Description
SYMBOL
TYPE
VCC
GND
D0-D7
I/O
RESET
I
CS
I
RD
I
WR
I
A0-A1
I
PA0-PA7
I/O
PB0-PB7
I/O
PC0-PC7
I/O
DESCRIPTION
VCC: The +5V power supply pin. A 0.1F capacitor between VCC and GND is recommended for decoupling.
GROUND
DATA BUS: The Data Bus lines are bidirectional three-state pins connected to the system data bus.
RESET: A high on this input clears the control register and all ports (A, B, C) are set to the input mode with the “Bus
Hold” circuitry turned on.
CHIP SELECT: Chip select is an active low input used to enable the 82C55A onto the Data Bus for CPU
communications.
READ: Read is an active low input control signal used by the CPU to read status information or data via the data bus.
WRITE: Write is an active low input control signal used by the CPU to load control words and data into the 82C55A.
ADDRESS: These input signals, in conjunction with the RD and WR inputs, control the selection of one of the three
ports or the control word register. A0 and A1 are normally connected to the least significant bits of the Address Bus
A0, A1.
PORT A: 8-bit input and output port. Both bus hold high and bus hold low circuitry are present on this port.
PORT B: 8-bit input and output port. Bus hold high circuitry is present on this port.
PORT C: 8-bit input and output port. Bus hold circuitry is present on this port.
Functional Diagram
POWER
SUPPLIES
+5V
GND
GROUP A
CONTROL
BIDIRECTIONAL
DATA BUS
D7-D0
DATA BUS
BUFFER
RD
WR
A1
A0
RESET
CS
READ
WRITE
CONTROL
LOGIC
8-BIT
INTERNAL
DATA BUS
GROUP B
CONTROL
GROUP A
PORT A
(8)
GROUP A
PORT C
UPPER
(4)
GROUP B
PORT C
LOWER
(4)
GROUP B
PORT B
(8)
I/O
PA7-PA0
I/O
PC7-PC4
I/O
PC3-PC0
I/O
PB7-PB0
FN2969 Rev 11.00
Dec 8, 2015
Page 3 of 30
Share Link: 