PSD302 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

PSD302

Low Cost Field Programmable Microcontroller Peripherals

STMicroelectronics 

PSD3XX Family

7.0

ZPSD

Background

(cont.)

Integrated Power Management TM Operation

Upon each address or logic input change to the ZPSD, the device powers up from low

power standby for a short time. Then the ZPSD consumes only the necessary power to

deliver new logic or memory data to its outputs as a response to the input change. After the

new outputs are stable, the ZPSD latches them and automatically reverts back to standby

mode. The ICC current flowing during standby mode and during DC operation is identical

and is only a few microamperes.

The ZPSD automatically reduces its DC current drain to these low levels and does not

require controlling by the CSI (Chip Select Input). Disabling the CSI pin unconditionally

forces the ZPSD to standby mode independent of other input transitions.

The only significant power consumption in the ZPSD occurs during AC operation.

The ZPSD contains the first architecture to apply zero power techniques to memory and

logic blocks.

t(s) Figure 2 compares ZPSD zero power operation to the operation of a discrete solution.

A standard microcontroller (MCU) bus cycle usually starts with an ALE (or AS) pulse and

c the generation of an address. The ZPSD detects the address transition and powers up for a

du short time. The ZPSD then latches the outputs of the PAD, EPROM and SRAM to the new

ro ) values. After finishing these operations, the ZPSD shuts off its internal power, entering

P t(s standby mode. The time taken for the entire cycle is less than the ZPSD’s “access time.”

te c The ZPSD will stay in standby mode while its inputs are not changing between bus cycles.

le u In an alternate system implementation using discrete EPROM, SRAM, and other discrete

so rod components, the system will consume operating power during the entire bus cycle. This

is because the chip select inputs on the memory devices are usually active throughout

b P the entire cycle. The AC power consumption of the ZPSD may be calculated using the

- O te composite frequency of the MCU address and control signals, as well as any other logic

) le inputs to the ZPSD.

ct(s bso Figure 2. ZPSD Power Operation vs. Discrete Implementation

Produ t(s) - O ALE

solete roduc ADDRESS

EPROM

ACCESS

SRAM

ACCESS

EPROM

ACCESS

OObbsolete P DISCRETE EPROM, SRAM & LOGIC

ICC

ZPSD

ZPSD

ZPSD

TIME

7

Share Link: