STK551U392A-E 查看數據表（PDF） - ON Semiconductor

零件编号

产品描述 (功能)

生产厂家

STK551U392A-E

Intelligent Power Module (IPM) 600 V, 15 A

ON Semiconductor 

STK551U392A-E

Parameter

Symbol

Conditions

Switching Character

Switching time

tON

tOFF

Io = 15 A

Inductive load

Turn-on switching loss

Turn-off switching loss

Total switching loss

Eon

Ic = 8 A,V+ = 300 V,

Eoff

VDD = 15 V, L = 3.9mH

Etot

Tc = 25C

Turn-on switching loss

Turn-off switching loss

Total switching loss

Eon

Ic = 8A, V+ = 300 V,

Eoff

VDD = 15V, L = 3.9mH

Etot

Tc = 100C

Diode reverse recovery energy

Diode reverse recovery time

Erec

Trr

IF = 8A, V+ = 400 V, VDD = 15 V,

L = 3.9mH, Tc = 100C

Reverse bias safe operating

area

Short circuit safe operating area

Allowable offset voltage slew

rate

RBSOA

SCSOA

dv/dt

Io = 30 A, VCE = 450 V

VCE = 400V, Tc = 100C

Between U,V,W to U-,V-,W-

Reference voltage is “VSS” terminal voltage unless otherwise specified.

Test

circuit

Fig.6

Ratings

min

typ

max

0.3

0.6

1.3

-

1.0

1.8

-

170

-

-

210

-

-

380

-

-

220

-

-

380

-

-

600

-

-

12

-

-

54

-

Full square

4

-

-

50

-

50

Unit

s

J

J

J

J

J

J

J

ns

s

V/ns

Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted. Product performance may not be

indicated by the Electrical Characteristics if operated under different conditions.

Notes :

1. When the internal protection circuit operates, a Fault signal is turned ON (When the Fault terminal is low level, Fault signal is ON

state : output form is open DRAIN) but the Fault signal does not latch.After protection operation ends,it returns automatically within

about 18 ms to 80 ms and resumes operation beginning condition. So, after Fault signal detection, set all input signals to OFF (Low)

at once.However, the operation of pre-drive power supply low voltage protection (UVLO : with hysteresis about 0.2 V) is as follows.

Upper side :

The gate is turned off and will return to regular operation when recovering to the normal voltage, but the latch will continue till the

input signal will turn ‘low’.

Lower side :

The gate is turned off and will automatically reset when recovering to normal voltage. It does not depend on input signal voltage.

2. When assembling the IPM on the heat sink with M3 type screw, tightening torque range is 0.6 Nm to 0.9 Nm.

3. The pre-drive low voltage protection is the feature to protect devices when the pre-driver supply voltage falls due to an operating

malfunction.

www.onsemi.com

3

Share Link: