PL-BYTEBLASTER2N 查看數據表（PDF） - Unspecified

零件编号

产品描述 (功能)

生产厂家

PL-BYTEBLASTER2N

ByteBlaster II Download Cable User Guide

Unspecified 

1. Setting Up the ByteBlaster II

Download Cable

Introduction

The ByteBlaster™ II download cable allows you to program and configure Altera®

devices. This cable drives configuration data from a standard parallel printer port on

your PC to the device on the PCB. Because design changes are downloaded directly to

the device, prototyping is easy and you can accomplish multiple design iterations in

quick succession.

Supported Devices

You can use the ByteBlaster II download cable to download configuration data to the

following Altera devices:

■ Stratix® series FPGAs

■ Cyclone® series FPGAs

■ MAX® series CPLDs

■ Arria™ GX series FPGAs

■ APEX™ series FPGAs

■ ACEX® 1K FPGAs

■ Mercury™ FPGAs

■ FLEX 10K® series FPGAs

■ Excalibur™ FPGAs

You can perform in-system programming of the following devices:

■ Advanced configuration devices including EPC2, EPC4, EPC8, and EPC16 devices.

■ Serial configuration devices including EPCS1, EPCS4, EPCS16, EPCS64, and

EPCS128 devices.

In addition, you can perform SignalTap® II logic analysis.

The ByteBlaster II download cable supports target systems using 5.0-V TTL, 3.3-V

LVTTL/LVCMOS, and single-ended I/O standards from 1.5 V to 3.3 V.

Power Requirements

The ByteBlaster II download cable requires between 1.5 V and 5.0 V from the target

circuit board.

The ByteBlaster II cable can be used in 1.8-V, 2.5-V, 3.3-V, and 5.0-V systems.

The ByteBlaster II VCC(TRGT) pin must be connected to the appropriate voltage for the

device that is being programmed. The pull-up resistors on the target circuit board for

the configuration/programming signals must be connected to the same power supply

as the ByteBlaster II VCC(TRGT).

© July 2008 Altera Corporation

ByteBlaster II Download Cable User Guide

Share Link: