LT1259 查看數據表（PDF） - Linear Technology

零件编号

产品描述 (功能)

生产厂家

LT1259

Low Cost Dual and Triple 130MHz Current Feedback Amplifiers with Shutdown

Linear Technology 

LT1259/LT1260

APPLICATIO S I FOR ATIO

The input slew rate of the LT1259/LT1260 is approxi-

mately 270V/µs and is set by internal currents and capaci-

tances. The output slew rate is set by the value of the

feedback resistors and internal capacitances. At a gain of

10 with at 1k feedback resistor and ±15V supplies, the

output slew rate is typically 1600V/µs. Larger feedback

resistors will reduce the slew rate as will lower supply

voltages, similar to the way the bandwidth is reduced.

The graph of Maximum Undistorted Output vs Frequency

relates the slew rate limitations to sinusoidal input for

various gains.

Large-Signal Transient Response, AV = 2

looks like a 4.4pF capacitor in parallel with a 75k resistor,

excluding feedback resistor effects. These amplifiers are

designed to operate with open drain logic: the EN pins have

internal pullups and the amplifiers draw zero current when

these pins are high. To activate an amplifier, its EN pin is

pulled to ground (or at least 2V below the positive supply).

The enable pin current is approximately 60µA when

activated. Input referred switching transients with no

input signal applied are only 35mV positive and 80mV

negative with RL = 100Ω.

Output Switching Transient

EN

VS = ±15V

RL = 400Ω

RF = RG = 1.6k

LT1259/LT1260 • AI01

Large-Signal Transient Response, AV = 10

OUTPUT

VS = ±5V

VIN = 0V

RF = RG = 1.6k

RL = 100Ω

LT1259/LT1260 • AI03

The enable/disable times are very fast when driven from

standard 5V logic. The amplifier enables in about 100ns

(50% point to 50% point) while operating on ±5V sup-

plies. Likewise the disable time is approximately 40ns

(50% point to 50% point) or 75ns to 90% of the final

value. The output decay time is set by the output capaci-

tance and load resistor.

Amplifier Enable Time, AV = 10

OUTPUT

VS = ±15V

RF = 1k

RG = 110Ω

RL = 400Ω

LT1259/LT1260 • AI02

Enable/Disable

The LT1259/LT1260 amplifiers have a unique high imped-

ance, zero supply current mode which is controlled by

independent EN pins. When disabled, an amplifier output

8

EN

VS = ±5V RF = 1k

RL = 150Ω

VIN = 0.1V RG = 110Ω

LT1259/LT1260 • AI04

Share Link: