7585AILZ 查看數據表（PDF） - Intersil
零件编号
产品描述 (功能)
生产厂家
7585AILZ Datasheet PDF : 19 Pages
| |||
EL7585A
Boost Converter
The main boost converter is a current mode PWM converter at
a fixed frequency of 1MHz which enables the use of low profile
inductors and multilayer ceramic capacitors. This results in a
compact, low cost power system for LCD panel design.
The EL7585A is designed for continuous current mode, but
they can also operate in discontinuous current mode at light
load. In continuous current mode, current flows continuously
in the inductor during the entire switching cycle in steady
state operation. The voltage conversion ratio in continuous
current mode is given by:
A-----V----D----D--
VIN
=
1-----–-1----D---
Where D is the duty cycle of the switching MOSFET.
Figure 19 shows the block diagram of the boost regulator. It
uses a summing amplifier architecture consisting of GM
stages for voltage feedback, current feedback and slope
compensation. A comparator looks at the peak inductor
current cycle by cycle and terminates the PWM cycle if the
current limit is reached.
An external resistor divider is required to divide the output
voltage down to the nominal reference voltage. Current
drawn by the resistor network should be limited to maintain
the overall converter efficiency. The maximum value of the
resistor network is limited by the feedback input bias current
and the potential for noise being coupled into the feedback
pin. A resistor network in the order of 60kΩ is recommended.
The boost converter output voltage is determined by the
following equation:
AVDD
=
R-----1----+-----R-----2-
R1
×
VREF
The current through the MOSFET is limited to 3.5A peak.
This restricts the maximum output current based on the
following equation:
IOMAX
=
IL
MT
–
-∆--2--I--L-
×
V-----I--N--
VO
Where ∆IL is peak to peak inductor ripple current, and is set by:
∆IL
=
-V----I--N-- × -D---
L fS
where fS is the switching frequency.
SLOPE
COMPENSATION
CLOCK
SHUTDOWN
& START-UP
CONTROL
Ifb
CURRENT
AMPLIFIER
Iref
FBB
GM
AMPLIFIER
REFERENCE
GENERATOR
PWM
LX
LOGIC
BUFFER
Ifb
Iref
VOLTAGE
AMPLIFIER
CINT
PGND
FIGURE 19. BLOCK DIAGRAM OF THE BOOST REGULATOR
9
FN7523.3
March 9, 2006
Share Link: 