NX25F011A 查看數據表（PDF） - NexFlash -> Winbond Electronics

零件编号

产品描述 (功能)

生产厂家

NX25F011A

1M-BIT AND 4M-BIT SERIAL FLASH MEMORIES WITH 4-PIN SPI INTERFACE

NexFlash -> Winbond Electronics 

NX25F011A

NX25F041A

Write Configuration Register

The Write Configuration Register command provides

access to the configuration register which stores the

current configuration of the HOLD-R/B pin, read-data

clock edge, write protect range, and alternate oscillator

frequency. The configuration register is non-volatile. Once

set using the Write Configuration Register command, the

contents will maintain even when power is removed.

Because the register’s state is stored in non-volatile

memory, there is a finite endurance limit to the number of

times it can be written to. To limit the number of writes, it

is recommended that before writing to the configuration

register it should first be read from using the Read

Configuration Register command. If no change is

required, the Write Configuration Register command can

be skipped. This process will help extend the endurance

of the configuration register bits and eliminate additional

programming “busy” time.

The Write Configuration Register command sequence

starts with the command byte (8AH) followed by a 16-bit

field that specifies configuration register bit settings.

Although the field is 16-bits long, only bits CF[8:0] are

used. All other upper bits are reserved and must be

clocked using 0 for data. After an additional 16 control

clocks using 0 for data, the command can be completed

by asserting CS high. The device will become busy for a

short time (tWP) while the non-volatile memory cells of the

configuration register are programmed.

Write

Configuration

Register Configuration

Command

Bits*

16 Clocks

SI

8AH

CF[15:0]

0000H

SO

*The CF Register only uses bits [8:0]

Read Status Register

The Read Status Register command provides access to

the status register and its status flags for Ready/Busy

(R/B), SRAM and program buffer transfer operations (TX),

Write Enable/Disable (WE), and Compare Not Equal (CNE)

(Figure 8). The command sequence is similar to the 0

command except that the sector address field S[15:0] and

the byte-address field B[15:0] are replaced by all 0 bits.

After 16 clocks and the Ready/Busy status field RB[15:0]

has been read, an 8-bit Status field ST[7:0] provides the

contents of the Status Register.

Read Status

Register

Command

16 Clocks

SI

83H

0000H

16 Clocks

0000H

16 Clocks

0000H

SO

RB[15:0]

ST[7:0]

Read/Busy Read Status

Status Register Bits

18

NexFlash Technologies, Inc.

PRELIMINARY NXSF014B-0699

06/11/99

Share Link: