CMX867 查看數據表（PDF） - CML Microsystems Plc

零件编号

产品描述 (功能)

生产厂家

CMX867

Low Power V.22 Modem

CML Microsystems Plc 

Low Power V.22 Modem

CMX867

1.5.1 Tx USART

A flexible Tx USART is provided for all modem modes, meeting the requirements of V.14 for DPSK

modems.

It can be programmed to transmit continuous patterns, Start-Stop characters or Synchronous Data.

In both Synchronous Data and Start-Stop modes the data to be transmitted is written by the µC into the

8-bit C-BUS Tx Data Register from which it is transferred to the Tx Data Buffer.

If Synchronous Data mode has been selected the 8 data bits in the Tx Data Buffer are transmitted

serially, b0 being sent first.

In Start-Stop mode a single Start bit is transmitted, followed by 5, 6, 7 or 8 data bits from the Tx Data

Buffer - b0 first - followed by an optional Parity bit then - normally - one or two Stop bits. The Start, Parity

and Stop bits are generated by the USART as determined by the Tx Mode Register settings and are not

taken from the Tx Data Register.

Figure 5a Tx USART

Every time the contents of the C-BUS Tx Data Register are transferred to the Tx Data Buffer the Tx Data

Ready flag bit of the Status Register is set to 1 to indicate that a new value should be loaded into the C-

BUS Tx Data Register. This flag bit is cleared to 0 when a new value is loaded into the Tx Data Register.

Figure 5b Tx USART Function (Start-Stop mode, 8 Data Bits + Parity)

If a new value is not loaded into the Tx Data Register in time for the next Tx Data Register to Tx Data

Buffer transfer then the Status Register Tx Data Underflow bit will be set to 1. In this event the contents

of the Tx Data Buffer will be re-transmitted if Synchronous Data mode has been selected, or if the Tx

modem is in Start-Stop mode then a continuous Stop signal (1) will be transmitted until a new value is

loaded into the Tx Data Register.

© 2004 Consumer Microcircuits Limited

11

D/867/5

Share Link: