M41T11 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

M41T11

Serial real-time clock (RTC) with 56 bytes of NVRAM

STMicroelectronics 

Clock operation

M41T11

adjustment per calibration step in the calibration register. Assuming that the oscillator is in

fact running at exactly 32,768 Hz, each of the 31 increments in the calibration byte would

represent +10.7 or –5.35 seconds per month which corresponds to a total range of +5.5 or

–2.75 minutes per month.

Two methods are available for ascertaining how much calibration a given M41T11 may

require. The first involves simply setting the clock, letting it run for a month and comparing it

to a known accurate reference (like WWV broadcasts). While that may seem crude, it allows

the designer to give the end user the ability to calibrate his clock as his environment may

require, even after the final product is packaged in a non-user serviceable enclosure. All the

designer has to do is provide a simple utility that accessed the calibration byte.

The second approach is better suited to a manufacturing environment, and involves the use

of some test equipment. When the frequency test (FT) bit, the seventh-most significant bit in

the control register, is set to a '1', and the oscillator is running at 32,768 Hz, the FT/OUT pin

of the device will toggle at 512 Hz. Any deviation from 512 Hz indicates the degree and

direction of oscillator frequency shift at the test temperature.

For example, a reading of 512.01024 Hz would indicate a +20 ppm oscillator frequency

error, requiring a –10(XX001010) to be loaded into the calibration byte for correction. Note

that setting or changing the calibration byte does not affect the frequency test output

frequency.

3.2

Output driver pin

When the FT bit is not set, the FT/OUT pin becomes an output driver that reflects the

contents of D7 of the control register. In other words, when D6 of location 7 is a zero and D7

of location 7 is a zero and then the FT/OUT pin will be driven low.

Note: The FT/OUT pin is open drain which requires an external pull-up resistor.

3.3

Preferred initial power-on defaults

Upon initial application of power to the device, the FT bit will be set to a '0' and the OUT bit

will be set to a '1'. All other register bits will initially power on in a random state.

16/30

Doc ID 6103 Rev 10

Share Link: