M215HW01-V6 查看數據表（PDF） - AU Optronics
零件编号
产品描述 (功能)
生产厂家
M215HW01-V6 Datasheet PDF : 25 Pages
| |||
www.DataSheet4U.net
Product Specification
AU OPTRONICS CORPORATION
M215HW01 V6
1.0 Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard
surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth
when handling.
7) Do not open or modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was taken
out from the container, do not press the center of the LED lightbar edge. Instead, press at the
far ends of the LED light bar edge softly. Otherwise the TFT Module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the
Interface Connector of the TFT Module.
11)
12)
ebMm(ASIveEfmooteneCddandruu6lilnill0mneeag9smom/5sttmawoh0aluoleiyasonunttrbiitltnodaUeognrLfbyd1o.meafo9fmAars5tcthtau0eeegdp)rs,ieepaTodsllaiFsrei.grTdbehneaMibnavaygopipndpppgtulhoileileneewdodeeinfretnltoaoxccmelootaImhmmnsneutppaeertlbeiTrinoeni,FlcndiatilT.ytolwsUsgMuihtrshraooeedud,reOleuddqlinoesublyineurfreos/otmte2amdtk0ewe0niionsnt9ustt/thi6nnsoe/oitf3dorLe0LbCc.imeoDOnnitdtsemhiddteoherdPewruaoiTlstewieFo.eTnTrthhMtSheeooaLudTt CruFnclDToee
Confidential For PROMATE
AUO
document version 1.0
4
Share Link: 