MF601F 查看數據表（PDF） - YCL Electronics

零件编号

产品描述 (功能)

生产厂家

MF601F

Mirco Filter For ADSL CPE Side

YCL Electronics  

Product Specification

MF601F

4.3 : DC characteristic :

All requirement of this specification can be met in the presence of all POTS loop currents

from 0mA to 100mA. This in line filter can pass POTS tip-to-ring dc voltages of 0V to 105V

and ringing signals of 40V to 150Vrms at any frequency from15.3Hz to 68Hz with a dc

component in the range from 0V to 105V.

The DC resistance from tip-to-ring at the line port interface with the phone interface shorted,

shall be less than or equal to 15 ohms for one splitter.The DC resistance from tip-to-ground

and from ring-to-ground at the POTS interface with the U-R interface open shall be greater

than or equal to 5 Megohms. The ground point shall be local building or green wire ground.

As an objective , the dc resistance should exceed 10MΩ.

4.4 : Test method :

4.4.1 : Insertion loss :

The insertion loss of a device connected into a given transmission system is defined as

the ratio,expressed in dB, of the load power available(before and after insertion ) delivered

to the output network beyond the point of insertion at a given frequency.In general , the

insertion loss is defined as the ratio, expressed in dB of the power delivered to a load with

the circuit in place and the power delivered to a load without the circuit in place.The added

insertion loss shall be measured using the test up in figure 3. For measuring POTS band

insertion loss for single filter module also a single filter wit four added parallel load

filters.General Insertion loss equation can be expressed as following

Insertion loss = 20 log V2 / V1 dB where

V1 = the measured voltage value of load without LPF in circuit.

V2 = the measured voltage value of load with LPF in circuit.

The test setup is shown in drawing below. :

Remote POTS Splitter

Test

ZL

Line

LPF

Phone Equipment

Data sheet subject to change without notice

ZL

Load#1 LPF

Load#4 LPF

ZL is normal Termination

in test set

RDPS-MF008(R1)07/03/2002

SHEET 7 OF 10

Share Link: