RMBA09500-58(1999) 查看數據表（PDF） - Raytheon Company
零件编号
产品描述 (功能)
生产厂家
RMBA09500-58 Datasheet PDF : 7 Pages
| |||
Raytheon
Raytheon Commercial Electronics
RMBA09500-58
Cellular/GSM 2 Watt Linear GaAs MMIC Power Amplifier
Application Information
PARTS LIST for Test Evaluation Board (RMBA09500-58-TB, G654188/G654942)
PART
VALUE
EIA SIZE
C1,C3,C10
39 pF
0402
C2
5.1 pF
0402
C8
10 pF
0402
C9
6.2 pF
0402
C4,C5,C11,C12 1000 pF
0402
C6,C7
4.7 uF
3528
L1
4.7 nH
0603
L2
22 nH
0603
L3
39 nH
1008
R1
10 Ohm
0402
W1
26AWG (0.015Ó dia) Wire
U1
RMBA09500-58
P3
Right angle Pin Header
P1,P2
SMA Connectors
Board
FR4
R2, R3,R4,R5 220 ohm
0402
Vendor(s)
Murata, GRM36COG390J050
Murata, GRM36COG5R1B050
Murata, GRM36COG10RB050
Murata, GRM36COG6R2B050
Murata, GRM36X7R102K050
TDK, C3216X5R1A475KT
Toko, LL1608-FH4N7S
Toko, LL608-FH22NK
Coilcraft, 1008HS-390TKBC
IMS, RCI-0402-10R0J
Alpha, 2853/1
Raytheon, G655978
3M (2340-5211TN)
Johnson Components (142-0701-841)
Raytheon Dwg# G655966, V1
IMS RCI 0402 2200J
Recommendations for Heat-Sinking the RMBA09500-58
PWB must be prepared with a heat sink, made of a highly conductive (electrical and thermal) material
such as copper or aluminum with necessary surface plating, attached to the backside of PWB where
the package is to be mounted on the front side. A small pedestal in the heat sink should protrude
through a hole in the PWB where the package bottom is directly soldered. Use Sn/Pb (67/37) solder (or
Sn/Pn/Ag 62/36/2 solder) at 220¡C for 20 seconds or less. The package bottom should be firmly
soldered to the pedestal while the pins are soldered to the respective pads on the front side of PWR
without causing any stress on the pins. To accomplish stress free mounting, the top surface of the
pedestal should be made flush with the top surface of PWB. Remove flux completely if used for
soldering.
This is advanced information which contains data on products in development. Characteristic
performance data and specifications are subject to change without notice.
Tel: 978-470-9421
FAX: 978-470-9201
www.raytheon.com/micro
Revised October 22, 1999
Page 5
Raytheon RF Components
362 Lowell Street
Andover, MA 01810
Share Link: 