SA676DK 查看數據表（PDF） - Philips Electronics

零件编号

产品描述 (功能)

生产厂家

SA676DK

Low-voltage mixer FM IF system

Philips Electronics 

Philips Semiconductors

Low-voltage mixer FM IF system

Product specification

SA676

RF GENERATOR

45MHz

VCC (+3)

SA676 DEMOBOARD

RSSI AUDIO

DC VOLTMETER

DE-EMPHASIS

FILTER

C–MESSAGE

SCOPE

HP339A DISTORTION

ANALYZER

Figure 4. SA676 Application Circuit Test Set Up

SR00517

NOTES:

1. C-message: The C-message and de-emphasis filter combination has a peak gain of 10 for accurate measurements. Without the gain, the

measurements may be affected by the noise of the scope and HP339A analyzer. The de-emphasis filter has a fixed -6dB/Octave slope

between 300Hz and 3kHz.

2. Ceramic filters: The ceramic filters can be 30kHz SFG455A3s made by Murata which have 30kHz IF bandwidth (they come in blue), or

16kHz CFU455Ds, also made by Murata (they come in black). All specifications and testing are done with the wideband filter.

3. RF generator: Set your RF generator at 45.000MHz, use a 1kHz modulation frequency and a 6kHz deviation if you use 16kHz filters, or

8kHz if you use 30kHz filters.

4. Sensitivity: The measured typical sensitivity for 12dB SINAD should be 0.45µV or –114dBm at the RF input.

5. Layout: The layout is very critical in the performance of the receiver. We highly recommend our demo board layout.

6. RSSI: The smallest RSSI voltage (i.e., when no RF input is present and the input is terminated) is a measure of the quality of the layout and

design. If the lowest RSSI voltage is 500mV or higher, it means the receiver is in regenerative mode. In that case, the receiver sensitivity

will be worse than expected.

7. Supply bypass and shielding: All of the inductors, the quad tank, and their shield must be grounded. A 10-15µF or higher value tantalum

capacitor on the supply line is essential. A low frequency ESR screening test on this capacitor will ensure consistent good sensitivity in

production. A 0.1µF bypass capacitor on the supply pin, and grounded near the 44.545MHz oscillator improves sensitivity by 2-3dB.

8. R5 can be used to bias the oscillator transistor at a higher current for operation above 45MHz. Recommended value is 22kΩ, but should not

be below 10kΩ.

1993 Dec 15

6–133

Share Link: