MAX6325(1997) 查看數據表（PDF） - Maxim Integrated

零件编号

产品描述 (功能)

生产厂家

MAX6325
(Rev.:1997)

1ppm/°C, Low-Noise, +2.5V/+4.096V/+5V Voltage References

Maxim Integrated 

1ppm/°C, Low-Noise, +2.5V/+4.096V/+5V

Voltage References

_____________________Pin Description

PIN

1, 7, 8

2

3

4

5

6

NAME

I.C.

IN

NR

GND

TRIM

OUT

FUNCTION

Internally Connected. Do not use.

Positive Power-Supply Input

Noise Reduction. Optional capacitor

connection for wideband noise

reduction. Leave open if not used

(Figure 2).

Ground

External Trim Input. Allows ±1%

output adjustment (Figure 1).

Leave open if not used.

Voltage Reference Output

_______________Detailed Description

Temperature Stability

The MAX6325/MAX6341/MAX6350 are highly stable,

low-noise voltage references that use a low-power tem-

perature-compensation scheme to achieve laboratory-

standard temperature stability. This produces a nearly

flat temperature curve, yet does not require the power

associated with heated references.

The output voltage can be trimmed a minimum of 0.6%

by connecting a 10kΩ potentiometer between OUT and

GND, and connecting its tap to the TRIM pin, as shown

in Figure 1. The external trimming does not affect tem-

perature stability.

Noise Reduction

To augment wideband noise reduction, add a 1µF

capacitor to the NR pin (Figure 2). Larger values do not

improve noise appreciably (see Typical Operating

Characteristics).

Noise in the power-supply input can affect output

noise, but can be reduced by adding an optional

bypass capacitor to the IN pin and GND.

Bypassing

The MAX6325/MAX6341/MAX6350 are stable with

capacitive load values from 0µF to 100µF, for all values

of load current. Adding an output bypass capacitor can

help reduce noise and output glitching caused by load

transients.

__________Applications Information

Negative Regulator

Figure 3 shows how both a +5V and -5V precision ref-

erence can be obtained from a single, unregulated +5V

supply. A MAX681 generates approximately ±9V to

operate the MAX6350 reference and MAX400 inverting

amplifier. The +5V is inverted by the ultra-low offset

MAX400 op amp. Resistor R1 is optional, and may be

used to trim the ±5V references. R2 and R4 should be

matched, both in absolute resistance and temperature

coefficient. R3 is optional, and is adjusted to set the -5V

reference.

8V TO 36V INPUT

IN

REFERENCE OUT

OUT

MAX6325

MAX6341

NR

MAX6350 TRIM

10k

GND

*

1µF

8V TO 36V INPUT

IN

REFERENCE OUT

OUT

MAX6325

MAX6341

NR

MAX6350 TRIM

GND

Figure 1. Output Voltage Adjustment

*OPTIONAL

Figure 2. Noise-Reduction Capacitor

8 _______________________________________________________________________________________

Share Link: